DIGITAL CAMERA EXTRA CAMERA FOR VIDEO BABY MONITOR V35US USER GUIDE Model: V43TX IMPORTANT: THIS PRODUCT CAN BE USED ONLY WITH BABYSENSE VIDEO MONITOR - MODEL V35US For any product related questions please contact us: service@hisense.co.
1. Warnings and Safety Instruc�ons Follow these safety precau�ons to prevent fire, injury or damage to the product. Read and keep instruc�ons: It is very important that you read all the safety and opera�ng instruc�ons before the Babysense video monitor is operated. Please retain your purchase receipt as you will need to produce it if warranty service is required.
device which must be handled with care. • This product is designed for INDOOR USE ONLY. • WATER AND MOISTURE: The product should not be exposed to rain, moisture, or splashing. Never use or place the product in or near moisture or water. • THIS PRODUCT CANNOT REPLACE RESPONSIBLE ADULT SUPERVISION: Your video monitor is designed to be an aid and should not be used as a subs�tute for responsible and proper adult supervision of a child.
• DAMAGE REQUIRING SERVICE: This product should be serviced by qualified personnel only. • DO NOT TRY TO OPEN AND REPAIR THE PRODUCT: If you have any problems with the product, please contact the authorized distributor. • In case of unusual noises or smells origina�ng from the device, immediately disconnect the product from the power outlet and contact authorized distributor. • If the product becomes dirty, use a lightly damp so� cloth to wipe surfaces, taking care to not allow water into any openings.
2 Overview 2.1 Pack Contents • Baby Unit x 1 • Wide angle lens x 1 • AC Power Adapter x 1 • Set for wall moun�ng x 1 • User Manual x 1 2.2 Baby Unit Overview 1 2 3 4 7 5 6 8 10 9 7 1. Infrared LEDs 2. Wide Angle Lens 3. Light sensor (Night Vision) 4. Power LED 5. Night Light 5 6. Microphone 7. Temperature Sensor 8. Speaker 9. DC Jack 10.
3 Ge�ng Started 3.1 Powering The Baby Unit (Camera) • Connect the Camera Power Adapter to the DC-Jack (9) on the back of the Baby Unit. • Plug the AC power adapter into the wall outlet. • The unit will power on automa�cally and the green power LED (4) will light up. • Unplug the Baby Unit to turn it off. NOTE: Only use the AC power adapter included in this package. 3.
light source or direct sunlight. Avoid installing the camera where there are thick walls or obstruc�ons between the camera and the monitor. • To use your parent unit and baby unit together, you must be able to establish a radio link between them; the range may be affected by environmental condi�ons/obstacles (See more details in Troubleshoo�ng Sec�on on page 11 - “Interference or poor recep�on”) 4 Opera�ng the Monitor 4.
NOTE: If there is more than one Baby Unit to be paired, repeat the above steps for each one individually. 4.2 Switching between the paired Baby Units (Cameras) NOTE: This func�on is only available when two or more cameras are paired. • To switch between the paired cameras, press the MENU/OK bu�on on your Parent Unit and the menu screen will pop up. • Press the LEFT bu�on or RIGHT bu�on un�l the CAM icon is highlighted in red.
• Then press the MENU/OK bu�on and a secondary menu with camera op�ons will pop up. • Press the LEFT bu�on or RIGHT bu�on un�l the Camera Loop icon (last op�on) is highlighted in red and press the MENU/OK bu�on bu�on to confirm. • Now the SCAN mode is ac�vated and the monitor will automa�cally switch between the paired Baby Units with an interval of 10 seconds. • On the top of the LCD display you will see the Loop icon. • Press the EXIT bu�on to exit the menu.
5 Using the Wide Angle Lens The supplied Wide Angle Lens provides be�er control over the viewing angle. It captures a wider viewing area, allowing you to see more around the Baby Unit. Best for ac�ve babies and toddlers. To use the lens, just screw it onto the Baby Unit as illustrated below: Screw the lens onto the Baby Unit Normal View Baby Unit with no Lens Wide Angle View Baby Unit with the Lens NOTE: Always ensure the lens is screwed �ghtly onto the Baby Unit.
7 Troubleshoo�ng Problem No recep�on on the Parent Unit Possible cause/solution • The power adapters may not be properly connected. • Ensure that the Baby and Parent Units are ON. • Adjust the monitor antenna to ver�cal posi�on. • Make sure the Baby and Parent Units are not far away from each other. • Baby and Parent Units may not be properly paired. Follow PAIRING instruc�ons on page 9. Interference or poor recep�on • Move the Baby unit closer to Parent unit. • Use of other 2.
Problem Possible cause/solution A high pitched • The Baby Unit and Parent Unit may be ear piercing too close to each other. Move them noise is heard further apart. from the units (feedback, sta�c) • The volume on the Parent Unit may be set too high. Lower volume. Cannot hear the baby sounds on the Parent Unit Background noises Picture is black and white Lines/marks across the screen The rechargeable ba�ery will not charge or no charge light shows • Volume se�ng on the Parent Unit may be too low.
IMPORTANT: If the above troubleshoo�ng guide did not help you solve your problem, please contact our customer service via: Email - service@hisense.co.il Toll Free Number – (833) 568-2229 Website - www.babysensellc.com (Refer to FAQ Sec�on) 8 Specifica�ons Product Model V43TX Frequency Transmission Range 2.
• Do not pull on the cable itself or bend the cable as that will put addi�onal stress on the cable and could lead to damages. • Do not touch the power adapter with wet hands or allow liquids to spill on it. • Make sure the mains adaptor cables are kept out of reach of your baby and other young children at all �mes. To avoid possible danger from power cords, the cords should be secured and never be hung on or near the crib. • Do not replace the plugs or cable on your power adapter.
• The ba�ery should not be exposed to direct sunlight or heat sources such as a candle, stove, radiator, heat register or other appliance that emit heat. • Do not modify, remanufacture, a�empt to insert foreign objects into the ba�ery, or immerse or expose it to water or other liquids. Ba�eries may explode if damaged. • Use only the ba�ery pack supplied with the product or the same type, sold by the manufacturer or its authorized distributors.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec�on against harmful interference in a residen�al installa�on. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc�ons, may cause harmful interference to radio communica�ons.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploita�on est autorisée aux deux condi�ons suivantes: (1) l'appareiI ne doit pas produire de brouillage, et (2) l'u�lisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est suscep�ble d'en comprome�re le fonc�onnement. 12 Warranty Terms We take quality very seriously.
Video Baby Monitor By