PI7 Manual
1. Carton Contents Please ensure the following items are included in carton: PI7 Headphones with ear tips (M) Charge Case USB-C Charging USB-C - 3.
2. Getting to Know Your Earphones 2.1 Switch Earphones On/Off Switching On/Off The PI7 does not have a power control and the power management is automatic. Your PI7 ear buds will charge when placed into the charging case and will be ready to use when they are removed from the charing case. If the ear buds are out of the charge case and not being used the earbuds will automatically go into a low power mode to conserve power. 2.
3. Battery Charging Your Bowers & Wilkins PI7 ships with the battery partially charged & may be used immediately. For best practice we recommend to fully charge the earphones before first use. Please allow up to 3 hours for full charge. The earphones can be used while charging. To charge the PI7 ear buds: 1. Place the PI7 ear buds int the charge case 2. Close the charge case lid To charge the PI7 charge case with cable: 1.
3.1 Status Indicator The status indicator is located on the charge case. When the ear buds are in the charge case the charge case indicator will show the battery charge level of the ear buds. When the ear buds are removed from the charge case the charge case indicator will show the battery charge level of the charging case.
4. Stowing the Ear Buds When not being worn in the ear, the PI7 ear buds can be stored and charged inside the charge case. The ear buds will be magnetically held in the charge case. The ear buds can only be stowed in one orientation Note: Take special care when wearing your earphones, hair or accessories trapped between your ears and the ear buds may interfere with proximity sensing.
5. Bluetooth Connectivity 5.1 Pairing Your Bowers & Wilkins PI7 earphones are designed to stream music wirelessly from Bluetooth audio devices, such as smartphones, tablets, or computers. To do so, the earphones & device must first be paired. When you receive your PI7 earphones they will be ready to pair to any Bluetooth audio device. 1. 2. 3. 4. 5.
6. Using PI7 6.1 Bluetooth Audio Sources Once paired to a Bluetooth audio source you can connect to the PI7 and all audio should be able to play all audio through the headphones 6.2 External Audio Sources The PI7 can be connected to external audio sources, such as in-flight entertainment systems. Simply connect the charge case to the external audio source with the USB-3.5mm connector cable and the audio will be transmitted from the charge case to the ear buds. 6.
6. Earphone Reset Your earphones can be reset to factory settings. To reset the earphones open the charge case with the ear buds placed inside. Press and hold the button on the inside of the charge case for 5 seconds or more and release. The indicator on the charge case will turn red to indeicate the reset.
8. Caring For Your Earphones Your earphones can be cleaned by a damp cloth and gently dabbing until clean. Do not use cleaning detergents, rubbing alcohol, or chemical cleaners/polish, doing so may damange your earphones.
9. Specifications Technical Features Bluetooth Codec Bluetooth Profiles Frequency Band RF output power Drive Units Audio Frequency Range Input Impedance Distortion (THD) Battery Life Charging Inputs Boxed Accessories Weight Operating temperature 11 True Wireless + techonlogy Bluetooth 5.0 with AptX Adaptive technology Auto ANC Audio streming from charge case Wireless and USB-C charging Fast charging support NFMI AptX – Adaptive AAC SBC A2DP v1.3.1 AVRCP v1.6.1 HFP v1.7.1 HSP v1.
10. Service / Support If you need help troubleshooting a specific problem, or simply have a question you would like answered, please initially consult the Headphone support section of the Bowers & Wilkins website: www.bowerswilkins.com.
