AW-CU282 Wireless LAN Module IC MFG Tool Command User Guide Version 0.1 Document release Date Ver. 0.
Step1: Initial Command As the information showed on your screen, please enter these commands below to start your test. Command: 1 Wi-Fi testing mode Step2: Generate 802.11 b/g/n Packet (1)Command: 22 1 12 1 22: Initial transmit power in the antenna 1: Set the wanted channel (1~14 for B/G/N mode) 12: Set the wanted power, typically G mode: 12 dBm/ B mode: 15 dBm 1: Set the mode, 1 G mode & N mode , 0 B mode (2)Command: 112 0 (only for N mode) 112: N mode HT20/40. 0: for HT20/40.
Step3: Generate 802.11b/g/n continuous symbol (1)Please re-type the Step5 (1)~(4) commands. (2)Command 17 1 13 17: Set continuous mode. 1: Enable data rate 13: 54 Mbps, other data rate, please refer the above table. After you type above command, you can measure the 802.11b/g continuous symbol in your RF test instrument. (3)Command 17 0 Stop transmitting continuous signal Step4: Test RX sensitivity Before test RX, the Marvell standard waveform is needed. Please contact Azurewave FAE for this issue.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. 3) Module approval valid only when the module is installed in the tested host or compatible series of host As long as 23 conditions above are met, further transmitter test will not be required.
