The 1000URX Receiver INTRODUCTION Thank you for selecting the Aden 1000 Series for your portable/ENG on-camera UHF wireless needs. We are confident that these Comp. bents will perform beyond your expectations. For over 40 years Aden Corporation fas been creating technologically advanced products. Hy taking advantage of the latest in CAD design and SMT production tech piques, Aden's engineers are able to produce products halt exceed the published specifications and perform well beyond the warranty priced.
TABLE OF CONTENTS OUTHIT RECEIVER VIE INTRODUCTION. RE GE VER 0 pri TURBOJET Setting the reservist | en or the $000URK LOSING THE 1000URX RECEIVER'S CONTROLS AND ot SPLAY Power Output Ce Mortar LCD Display THE TO00URXAR THE 000BT TRANSMITTER Powering the 10008Y Tra SETTING THE TRANSMITTING FREQUENCY ON THE 100 USING THE TRANSMITTER'S CONTROLS AND Diem Power. Audio MIC nfl Ler THE 1000XT ¥ Power Hack page Back page CATIONS LICENSING... RECEIVER (1000URX) SETUP A.
RECEIVER (1080URX} SETUP (continued) A, Attaching the antennas to the 1000URX: To fallacy te high-gain antennas fo the 1000URMX, fit the BNC conned wise. tor on the antenna 0 the receiver [QU], press down and relate clo To remove the antennas, rotate the antenna’s BNC connector counterclockwise and pull up. 8.
THE 1000URX RECEIVER'S CONTROLS AND DISPLAY (continued) As the RF signed from the transmitter gets stronger {or weaker) the number of Ruminated LOD segments in fe display will change with 3 segment the maxim and best. Similarly, the AF {audio level} si meets wil fight from 1 to 3 segments as the audio gets stronger or weaker. in this case the best level the display shows between 2 and F segments.
SETTING THE TRANSMITTING FREQUENCY ON THE 100087 Before the 1000BT can be used, it and the associated receiver have to set fo the same frequency. This can be accomplished on the 100087 transmitter by first selling he LCD display o ore of two views Tre fluency or ‘Channel’. To do this, after ing a fresh battery, tum the 1000BT to the ON position [3].
3. Display (continued) fife {from 1 to 3 segments) with 3 resentments meaning maximum battery power. The bottom segment will bilks when the battery power falls to fess than 6.2V and indicates that iris ime to replace the battery, Aden recommends the use of Alkaline batteries only, Acres the top of the display, up to 5 segments will laminate depending on the strength of the transmitted audio signal -~ from 2 (weak) 1 5 {strong}.
USING THE 1000XT TRANSMITTERS CONTROLS AND DISPLAY A Po war The POWER ON/OFF switch tums the 1000KT ON or OFF 8. Audi Prince to first turning the 1000XT ON iris best {o set the AUDIO swi [B11 STY (standby). When you are ready to begin transiting fo ON. The STY position acts as & mute’ that maintains the RF signal but tums off the audio, Aeneid ess KOHL C.