Quick Setup Guide

WIRING

ILLUMINATE THE NIGHT
801 West Robinson Drive, Suite 500, North Salt Lake, UT 84054
q801/519-0500
< 801/519-0501
%
[e-mail]
Made in the USA
Lifetime Warranty

Illuminator will trigger ON/OFF using the built in ambient light sensor
which has been pre-set to a threshold of 5-15 lux. ON will trigger
immediately while OFF will trigger after a 12-18 second delay.
You will need to log into the camera via computer and program
the I/O ports to trigger when IR illumination is desired.

OPTION 1 Constant ON
OPTION 2 Automatic
OPTION 3 External Controller (e.g. Camera)
QUESTIONS ? [phone] or [e-mail] │axtontech.com
WARNING! Infrared light is not visible.
Do not view directly with optical instruments (magnifiers)
or stare directly into the illuminator at close distance.
Applying voltage other than the required range may
cause permanent damage and VOID WARRANTY
POWER
Apply only
PoE or PoE+
power to this unit over the
attached Ethernet cable.
Do not attempt to open or modify the light as this will void the
warranty. If you need a modification, electric or physical, contact us
directly. We will let you know if it can be done. All changes MUST be
made at our factory.
To switch illuminator ON, your camera
Output port(s) have to be ACTIVE and set
to LOW (GND-ground).
You may associate this action with various
events (IR cut filter, motion detection, etc.)
available on your camera or external device.
TO / FROM ILLUMINATOR
TO/ FROM CAMERA
Blue
GROUND
Brown
OUTPUT
INPUT
Blue/ White
Brown/ White
DAY/ NIGHT
AXTON Illuminators have been designed and tested to run 24/7
continuously both indoors and outdoors.
Jumper
Blue
GROUND
Brown
OUTPUT
INPUT
Blue/ White
Brown/ White
DAY/ NIGHT
TO / FROM ILLUMINATOR
Jumpers
Blue
GROUND
Brown
OUTPUT
INPUT
Blue/ White
Brown/ White
DAY/ NIGHT
TO / FROM ILLUMINATOR
Make all electrical connections
BEFORE applying power.
TTTTTTT

ILLUMINATE THE NIGHT
Quick Setup Guide MegaPixel
PoE Powered Infrared