Introduction Thank you for choosing Axiom DMR Digital Radio. We believe that you made a wise choice for we applying the best technology, the most stable components and advanced productive technology. Axiom radio will provide you with stable performance and high quality. This user manual apply to: Axiom AXP510T Safety Instruction Please comply with the following tips for fear of any accidents such as fire disaster, personal injury or radio damages. +Do not modify this radio or its charger in any way.
Axiom Radios quality warranty and liability The warranty range and limitation Axiom admitted to customer, during the quality warranty commitment, products are repaired or replaced by free, the radio which has been repaired or replaced is still in the quality warranty period, but the replaced components or circuit board are owned by Axiom. The warranty policy not include the flowing condition 1.
Unpacking and device check Please take the radio out of the package carefully, and before abandon the package material, we advise you to check the accessories according to the following list. If any part is lost or damage, please give the claim letter to the carrier or deliverer.
Battery use notes . Don't use the damaged charger or battery. 2. Don't us the battery for other purpose. 3. The charging time should be calculated by the power left inside, battery type and charger. Our battery can be recharged for more than 300 times and you had better change new one if the time is much shorter than normal. 4. The battery will run out of energy if not be used for long time. Li-ion battery charging indication ‘When the power is too low, recharge it before use.
Getting start Assemble the antenna Insert the antenna into the threaded receptacle at the top of the transceiver and turn clockwise until the antenna is firmly attached. Do not over tighten. = — == Assemble the belt chip Fix the belt clip in the upper end of , rear side with two screws until they Va arc screwed down. Disassemble the two screws from the belt clip with a screwdriver. Assemble SP/MIC Fix the rubber cover when not use. Open the rubber cover to insert the earphone.