User's Manual

Connection Using Ethernet (RJ45) Ports

Although the Modem comes with drivers and enabling software, you don’t have to

install and use them if you simply want to connect to the Internet through the

Ethernet (RJ-45) ports, assuming that your Modem has been activated with the

network

If you have MV400R-series, first go to AxessManager Operation Guide to

authenticate and configure your RUIM (if needed) before returning to the below

instructions.

Configuring Your PC

The Modem’s Ethernet is configured with DHCP by default. This means that IP

address of your PC is automatically assigned by the EV-DO Modem. If for some

reasons, the PC’s cannot get IP address and cannot make connection to Internet,

use the following steps to check the TCP/IP setting of your “Local Area

Connection”.

1. Click the Start button, select S

and select Control Panel. Click on

“Network and Internet Connectio

ettings,

n” icon.

NOTE: DHCP stands for Dynamic Host Configuration Protocol. Your Modem has

a built-in DHCP server. The DHCP server will automatically assign an IP

address to the computers on the LAN. Be sure to set each client PC’s

TCP/IP settings to “obtain an IP address automatically”.