User's Manual

Connecting to Data Service with USB connection

After USB driver has been installed, you must use AxessManager

to configure

and connect the Modem to the network. Please refer to AxessManager

Operational Guide chapter for detailed instructions. Make sure the Modem

selector switch is set to USB position before attempting the connection.

Normally Windows OS will automatically detect your Modem USB connection after

you have installed AxessManager. If for some reasons Windows OS failed to

complete this task, you may need to perform the following steps

after installing

AxessManager to fully configure your Modem in USB mode.

1. Verify in Network Connection window that

USB connection has been created in “Dial

up” section. The connection name is set by

your service provider (default name is

1xEvDO). You can also find the connection

name in AxessManager utility, USB

Connection Profile tab

2. If no USB connection appears in Dial up

section, go to AxessManager utility, USB

Connection Profile tab, highlight the

connection name your service provider has

created, click Edit and OK to accept the

setup. This will add the connection to the

Network Connection window.

3. In very rare cases, Windows OS may

associate the wrong modem to your Dial up

connection. To verify, right click on the Dial

up connection name in step 1 above and

select Properties. You should see the

Axesstel USB Modem selected and the

correct dial number entered. If not, update

the fields with correct value.