User's Manual

User manual of Wireless Door/ window Sensor

Model no.: AI113

The wireless door/window Sensor are widely used in security alarm system and matched with master unit for usage. It is

equipped with a magnet (movement of the magnet triggers an internal sensor in the detector). You can locate the

transmitter module on the frame of the door or window, with the magnet on the moving part of the door or window, It will

send RF signal to the master unit for alarming once be triggered (disconnect).

Specification：

1. Operating voltage：12VDC

2. Static current ≤2µA

3. Operating current ≤30mA

4.Operating frequency：433.92MHZ+/-0.2MHz

5.Transmitting time：<3S

6.Transmitting Field Strength: ≤80.8 dBuV/m

7.Size：31x95×16mm（transmitting partion）， 14x16x99mm (magnet partion)

8.Encode IC：EV1527

9.Modulation Mode: ASK

10.Opearating temp：-20℃ ~ +50℃

11.Battery: 12V23A

12. LED: Trigger transmitting indication

Installation

The wireless door /window Sensor is used to detect whether the door, windows or drawers are opened or moved illegally.

It constitutes by wireless transmitting module, magnet, double faced adhesive tape (accessory). As the Figure 1 shows

as follow:

Wireless Transmitting Module

Magnet

Double Faced Adhesive Tape

Figure 1

Figure 2

Installation Process:

Step 1: Open the packing and take out the wireless transmitting module and the battery, pull down the slip cover of the

battery jar as Figure 3 shows.

Step 2: Fix the battery (12V 23A) into the jar and close the slip cover as Figure 3 shows .

Step 3: Paste the double faced adhesive tape on the back of the module and the magnet as Figure 4 shows. The

module and the magnet also have screw holes so that it can be fixed by screw too.

Step 4: Fix the two parts on the door as Figure 5 shows. Please press them hard when paste in order to prevent

dropping caused by the door’s shaking.

PAGE 1
User manual of Wireless Door/ window Sensor Model no.: AI113 The wireless door/window Sensor are widely used in security alarm system and matched with master unit for usage. It is equipped with a magnet (movement of the magnet triggers an internal sensor in the detector). You can locate the transmitter module on the frame of the door or window, with the magnet on the moving part of the door or window, It will send RF signal to the master unit for alarming once be triggered (disconnect). Specification： 1.
PAGE 2
Figure 3 Figure 4 Figure 5 Attentions: Before sticking the module, please clean the area where you plant to stick it. a. Dust or humidity may cause the module fall off. b. Parallel the module and the magnet exactly, and the distance should be less than 10mm. Once the two parts have a distance above 20mm, the indicator light will shine and the module will send alarm signal to the unit base. Make door contact upward vertically. c.