uAxcess XJ-1023 Users Manual - 041419
COPYRIGHT ACKNOWLEDGEMENTS The contents of this document are the property of Applied Wireless Identifications Group, Inc. (AWID) and are copyrighted. All rights reserved. Any reproduction, in whole or in part, is strictly prohibited. For additional copies of this document please contact: AWID 18300 Sutter Blvd Morgan Hill, CA 95037 http://www.AWID.com The information contained herein has been carefully checked and is believed to be accurate, no responsibility is assumed for inaccuracies.
Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi products marketed in US must be fixed to US operation channels only.
Table of Contents REVISION HISTORY.................................................................................................... 5 1 INTRODUCTION....................................................................................................... 6 1.1 1.2 1.3 2 SPECIFICATIONS .................................................................................................... 7 2.1 3 Measure Read Distance.....................................................................................
REVISION HISTORY Version No. 1.0 1.
1 INTRODUCTION AWID's uAxcess XJ-1023 Reader is a smart card reader for switch plate mounting. This Reader will provide simultaneous Wiegand and RS-232 output formats. Its primary applications are Access Control and Time & Attendance applications. 1.1 GENERAL DESCRIPTION 1.2 SPECIAL FEATURES 1.
2 SPECIFICATIONS Input voltage Input current Read range Smart Card (ISO-14443 A/B) Transmit frequency Receiver frequency Operating temperature range Output format available Color 2.1 .....................+5V to +12 V .....................250 mA minimum ………………Up to 1.5 inches (3.8 cm) ......................13.56 MHz ......................13.56 MHz .....................-30° C to +65° C (-22° F to 149° F) …….………..Wiegand & RS-232 (Standard) ......................
XJ-1023 -8- 10/2/2019 Use recommended cable. Do not use any un-shield "Twisted Pair" type cable. Use the largest wire gauge possible. Use dedicated and linearly regulated power supply, where applicable. Use Single Point Grounding (Earthing). No ground loops. 3.3 METAL MOUNTING The Reader is pre-compensated for mounting on metal utility boxes. 3.4 GENERAL WIRING REQUIREMENTS All the Reader wiring must be continuously shielded.
XJ-1023 -9- 10/2/2019 Figure 1 Wiring Diagram for Wiegand Output Format Figure 2 Wiring Diagram for RS232 Output Format 4 Warranty AWID’s products are warranted to the original purchaser to be free of defects in material and workmanship for the life of the product. Any tampering or modification to the product will void this product warranty. AWID does not warrant any product as to its merchantability or suitability of use.