User's Manual

ManualsBrandsAVID ID Systems ManualsElectronicsMinitracker Pro Euro Wand Reader

AVID ID Systems, Inc.

MiniTracker Pro Euro Wand Reader

User’s Manual

Multi Mode Reader

FCC ID: IOL-134-AV1044

The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired

operation.

WARNING: This equipment has been tested and found to comply with the limits for Class A digital device

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause interference in which case the user will be required to correct the

interference at his own expense.

The user is cautioned that changes and modifications made to the equipment without approval of the

manufacturer could void the user's authority to operate this equipment.

For information:

Within USA 1(800) 336-2843

Outside USA +1(951) 284-1300

Fax +1(951) 737-8967

http://www.AvidID.com

3185 Hamner Avenue

Norco, California

USA, 92860

Summary of content (4 pages)

PAGE 1
AVID ID Systems, Inc. MiniTracker Pro Euro Wand Reader User’s Manual ©2009 AVID Multi Mode Reader FCC ID: IOL-134-AV1044 The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. 2. This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation.
PAGE 2
Congratulations on the purchase of your new AVID MiniTracker Pro Euro Wand Reader This reader is capable of reading AVID, and many other brands of electronic identification tags using the FECAVA or ISO (FDX-B) protocols. INSTRUCTIONS: How to use the AVID Wand Reader: 1. Power Switch: Turn the reader ON by sliding the lower right hand switch on the face of the reader, forward. When the reader is powered on, it will emit a double beep sound and the LCD will display AVID/FEC/ISO EU.
PAGE 3
The Wand Reader antenna, handle and switch are waterproof and can be completely immersed underwater as long as the Reader itself is kept out of the water. Chip orientation plays a major role in optimum performance of the reader and reading distances. In the figure below, CHIP A, in a parallel orientation to the antenna, will achieve its maximum reading distance towards the center of the coil.
PAGE 4
Operating the Reader Near Metal Metal objects (especially ferrous metals) absorb electromagnetic fields. Operating the reader antenna or placing the chip too close to metal object can severely limit the range of operation of the system. If you are experiencing reduced operating range of your system, check for metal tabletops, doors, etc. in close proximity (a few inches) to any part of the chip/reader environment.