User's Manual

ManualsBrandsAVID ID Systems ManualsElectronicsMTS Wand Reader

AVID ID Systems, Inc.

MiniTracker 3 Wand Reader

User’s Manual

Multi Mode Reader - Model # AVID1043

Manufactured under one or more of the following U.S. Patents:

5,235,326 5,266,926 5,559,507 6,172,609

FCC ID: IOL-125-AV1043

INSTRUCTION TO THE USER

This equipment has been tested and found to comply with the limits for a class B digital device pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

* Reorient or relocate the receiving antenna.

* Increase the separation between the equipment and receiver.

* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

* Consult the dealer or an experienced radio/TV technician for help.

Operation with non-approved equipment is likely to result in interference to radio and

TV reception. The user is cautioned that changes and modifications made to the

equipment without the approval of the manufacturer could void the user's authority to

operate the equipment.

For information:

Within USA 1(800) 336-2843

Outside USA +1(951) 284-1300

Fax +1(951) 737-8967

http://www.AvidID.com

3185 Hamner Avenue

Norco, California

USA, 92860

Summary of content (4 pages)

PAGE 1
AVID ID Systems, Inc. MiniTracker 3 Wand Reader User’s Manual ©2010 AVID Multi Mode Reader - Model # AVID1043 Manufactured under one or more of the following U.S. Patents: 5,235,326 5,266,926 5,559,507 6,172,609 FCC ID: IOL-125-AV1043 INSTRUCTION TO THE USER This equipment has been tested and found to comply with the limits for a class B digital device pursuant to part 15 of the FCC Rules.
PAGE 2
Congratulations on the purchase of your new AVID MiniTracker 3 Wand Reader This reader is capable of reading AVID, and many other brands of electronic identification tags using the FECAVA, TROVAN or ISO (FDX-B) protocols. INSTRUCTIONS: How to use the AVID Wand Reader: 1. Power Switch: Turn the reader ON by sliding the lower right hand switch on the face of the reader, forward. When the reader is powered on, it will emit a double beep sound and the LCD will display AVID/FEC/TR/ISO.
PAGE 3
The Wand Reader antenna, handle and switch are waterproof and can be completely immersed underwater as long as the Reader itself is kept out of the water. Chip orientation plays a major role in optimum performance of the reader and reading distances. In the figure below, CHIP A, in a parallel orientation to the antenna, will achieve its maximum reading distance towards the center of the coil.
PAGE 4
Operating the Reader Near Metal Metal objects (especially ferrous metals) absorb electromagnetic fields. Operating the reader antenna or placing the chip too close to metal object can severely limit the range of operation of the system. If you are experiencing reduced operating range of your system, check for metal tabletops, doors, etc. in close proximity (a few inches) to any part of the chip/reader environment.