link System Manual B62-01345 installation Overview Antenna Installation Installation of the p Link is described under the following four main heading a. Installing the Outdoor Unit (OU) and Integral Antenna. b. Installing the Indoor Unit (IU). c. Installing the TURNOUT Interconnection Cable, d. System Commissioning Appendix A at the end of this chapter supplements the installation procedure. It provides connector pin details for the external connectors of the IU and OUs.
wink System Manual Cuspidor Unit Installation Page 26. H62-01545 Follow these steps to mount the GU ont the Antenna, See Figure 6 and Figure 7. Stop Action 1 Loosen the three OU securing stand-off nuts located on the Antenna {see Figure 6). 2. Position the OU on the stand-off nuts through the three (3) key hole slots on the OU (see Figure 7). 3. Tighten the securing stand-off nuts, Outdoor Unit —Mounting Keyhole Shots Figure 7.
pink System Manual 862-01 Liquidator Unit Cable i Connector Step Action 6. Make-off the 1200 (BI W000 (TT) ~ faction set tributary input and output connections and connect to the JR-12 connector on the rear pane of the IU. Alternatively, connect the T32 (factory set) coaxial tributary connection to the BNC input and output connectors on the TU rear panel as required. See Appendix A at the end of this chapter for the pin details of the relevant tributary connector type, 7.
like System Manual BE-015 Support nit WHO Cable Connector Interconnection Cable Page 30 Figure 3. Outdoor Unit Mounted on Antenna. 4 Issue 1 86201545 like System Manual System After completing the physical installation of the Indoor Commissioning Unit, Antenna and Outdoor Sit, and the Interconnection Cable, vou must commission the System. This describes how io set up the minimum requirements for successful plank System operation.
link System Manual 86201545 862-01543 link Stern Manual Appendix A to Chapter 2: Link Error Perform a link error performance test as follows: Performance Co Co kink External Connector Pin Details Test 1. Run data over the link for a period of 135 hows. 2. Record the ROSY 3. Record the BER 4. Record the LED seamstress Indoor Unit Connector Pin Details . E1 BATS (JU Rear Panel) Record all results on w check fist. See Table 4 for an 3-pin JR-12 Female Connector Pin Details example.
slink System Manual 862-0345 Indoor Unit Connector Pin Details MONITOR (3U Front Panel) S-pin D-type Female Connector Pin Details Ground 1,4,6,7,8,9 Wot Used AUX VQ (IU Rear Panel) 15-pin High Density In type Female Connector 6000 15 ose | ! Pin Details 1 Relay 1 Common 2 Relay I NO 3 Relay | NO 4 Relay I N.C § Relay 1 N.C 6 Relay 1 Common 7 Relay 2 Common 8 Relay 2 Common 9 Relay 2 N.
link System Manual BO2-G13545 Outdoor Unit Connector Pin Details CABLE CONNECTOR (OU Base) CCHPRTEZOACTOMB OOD > Details 24V 24V TXCTXC+ TXDCLKRXDCLEH TXDCLK+ NIC RADCLIFFE RX Rx RX BRYCE TXDTHD+ GND GND GND GND GND GND GND GND GND GND Page 36 Issue | 8612-01548 link System Manual Chapter 3: Operational Information introduction to Chapter 3 provides the user with a description and the Chapter 3 location of all controls, eradicators and connectors located on the front and rear panels of the Link Indoor Unit
pink System Manual 862-01545 862-01545 stern Manual Near Alarm Alarm LED aN JS LED Table 8. IU Front Panel: Controls, Indicators and Connectors Item Description Near Alarm LED Used to indicate Failure, Service and Site alarms or status. The LED are tr-colour to indicate No Alarm (Green), Existing Alarm (Red) and Historic Alarm (Amber) conditions. Refer to Chapter 3, Maintenance Information for more details about these alarms.
plunk System Manual &62-01345 §62-01545 u Link System Manual Table 6. Status LED: aw | @w TTT LED Status Remarks indoor Unit (IU) Rear Panel Controls, Power On Off Power Off Indicators and Figure 11 shows all items on the 11] Rear Panel. Ted Power On Connectors Table 7 describes the items shown in the illustration.
plunk System Manual 862-0154 Table 7. IU Rear Panel; Controls, Indicators and Connectors Item Description Outdoor Unit Cable 26-pin, High Density D-type female connector for Connector 1U/OU interconnection cable. Wayside Traffic 9-pin D-type female connector, Used for Wayside Serial Data Connector traffic channels. DC Power Connector Welland 2-av chassis mounted connector, Auxiliary 110 5-pin, High Density D-type ferule connector.