Installation Manual

Table Of Contents

REGULATORY COMPLIANCE INFORMATION

Product: SDIO Wireless Module

Model: SX-SDMAN

For OEM integration only – device cannot be sold to general public.

FCC ID: GU6-SDMAN

IC: 1502A-SDMAN

WARNING：

The FCC / The Industry Canada regulations provide that changes or modifications not expressly

approved by the party responsible for compliance could void the user’s authority to operate the

equipment.

Manual and Product Labeling information to the End User:

The end user manual shall include all required regulatory information/warning

as shown in this manual. And when this module is installed in the host

product, you must include a Contain FCC ID: GU6-SDMAN and a Contain IC

ID: 1502A-SDMAN in the label of the host product.

NOTICE - Federal Communication Interference Statement (United

States only)

This equipment has been tested and found to comply with the limits for a class

B digital device, pursuant to Part 15 of the FCC rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

♦ Reorient or relocate the receiving

ntenn

♦ Increase the separation between the equipment and

eceiver.

♦ Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

♦ Consult the dealer or an experienced radio/TV technician for help.

This device and its antenna(s) must not be co-located or operated in conjunction with any other

antenna or transmitter.

DRAFT

PAGE 1
R E G U L AT O R Y C O M P L I A N C E I N F O R M AT I O N Product: SDIO W ireless Module Model: SX-SDMAN For OEM integration only – device cannot be sold to general public. FCC ID: GU6-SDMAN IC: 1502A-SDMAN WARNING： D The FCC / The Industry Canada regulations provide that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PAGE 2
Canadian Department of Communications Industry Canada Notice (Canada only) This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. FCC Rules, Part 15 / Industry Canadian This device complies with Part 15 of FCC Rules and Industry Canada license-exempt RSS standard(s).
PAGE 3
Le présent appareil est conforme aux la partie 15 des règles de la FCC et CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : ♦ l'appareil ne doit pas produire de brouillage, et ♦ l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.