User's Manual

Avery Dennison® and Pathfinder® are registered trademarks of Avery Dennison Corporation.
TC6052RCDAD Rev. AC 1/16 ©2015 Avery Dennison Corp. All Rights Reserved.
Pathfinder® 6052 Printer
FCC Information
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that
may cause undesired operation of this device.
Radiation Exposure
This equipment complies with FCC radiation exposure limits under Specific
Absorption Rate (SAR) tests for portable devices operating closer than 20
cm to nearby persons, set forth in an uncontrolled environment. This
equipment has been demonstrated to meet these RF emissions safety limits.
This transmitter is restricted to indoor use only within the 5.15 – 5.25 GHz
and 5.47 – 5.725 GHz bands.
Labeling Requirements
The final end product must be labeled in a visible area with the following
notice:
Contains FCC ID: GU6-SDCSSD40NBT
DRAFT