OPERATING INOTRHUUGITIUNS Wanderer ll {model 7400} is a radio frequency (RF) device used to provide a cable less solution to communications between a Symbol® 3800 data collection terminal and a Meonarch® 9450™ or 9480™ printer. It has two modules; one attaches to each device. The printer and the terminal can be used up to 3 meters apart. Following are diagrams of the printers and the terminal with the Wanderer || modules attached.
. Press both sides of the L-shaped module in and snap it into the optical interface beneath the terminal (at the bottom of the keyboard}. Printer Installation | To install Wanderer Il onto the printer: 1. Attach Velcro® to the outside of the printer and the box module. Place the Velcro such that the cable on the box module can easily reach the printer's serial port. 2. Using the Velcro, attach the box module to the outside of the printer.
Operating Wanderer II Clerks Only. To operate Wanderer 11: 1. Place the data collection terminal and the printer within 6 feet of each other and turn them on. Wait 2 seconds for the printer to run a status check. 2. Turn on the Wanderer [I module attached to the printer {green LED constant). Then, turn on the data collection terminal's module (green LED constant). The two devices link and the green LED starts to blink. . 3. Use the printer and the terminal as you normally would, Troubleshooting \ Following
Frequently Asked Questions Following are common questions (and the answers) asked about Wanderer have to use the Wanderer [| modules as selective pairs? A: No.The modules link to any other module, but only one at a time. Q: 1s there more than one operating frequency? A: Yes. However, the modules operate al only one frequency at a time. This frequency is selected when ordering and the factory sets it. The frequency cannot be changed in the field.