BETA - 2 device control system trigered by projector power consumption User’s manual Read these instructions carefully before operating the screen.
Dear Customer, Thank you very much for the purchase of our product. The manual booklet contains all operation information you may require to install properly and operate the radio remote control system. We hope it will help you to get the most enjoyment of your new control system. Enjoy time with the Avers Screens product. SAFETY INFORMATION NOTICE: Important safety information. Follow the instructions described in the operating manual for safety reasons.
Frequently examine the control system installation for imbalance and signs of wear or damage to cables. Do not use if repair or adjustment is necessary. Watch the moving screen and keep the people away until the screen is completely rolled in/out. It will help to avoid injuries caused with moving screen. All installation work should be carried out by the qualified technician. Improper installation can cause device damage or health breakdown. Do not do anything that may damage the power cables.
2.1 Contents of packaging Please, check carefully if any physical damage of the control system has not happen during transportation. Inspect the package for all accessories presented below: x2 x1 Control unit x 1 Wall plug converter x 1 IR accessories Operation manual x 1 2.2 Technical Data Control Unit: IR Transmitter/Receiver: Dimensions: 153 x 108 x 58 mm Dimensions: Ø13 x 40mm (2 x 13x8x5mm) Supply voltage: 220-240V, AC 50Hz Connection cable length: 145cm Control votage: 220-240V, AC 50Hz Max.
3.3 Electric installation - Lead out the power cables to the place of Control Unit installation. - Control Unit power line should be fused with 3,15A fuse. - Switch off the screen power line during installation work.
d) Switch on the projector with “Power ON” button located at the projector body or it’s remote transmiter. e) LED1 indicator will blink 3 times and douse to confirm the power consumption level was recognized and memorized. !!!CAUTION!!! Programming procedure must be performed each time attached projector is replaced with an other unit/model Beta control system is ready for usa as soon as the programming procedure is finished. 4.
5. Warranty conditions 1) Avers control system warranty period is 24 months from the date of purchase confirmed with the original purchase invoice. 3) Surety commits to fix free of charge any failures (component or production defects) of the product which appear during warranty period.
140,00 !!! CAUTION !!! Check the holes printed at the template match the location of fixing points at the control unit before you use it. 76,00 Manufactured after 13.08.2005 This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste.