Radio triggered control system C12VRC User’s manual Read these instructions carefully before operating the screen.
Dear Customer, Thank you very much for the purchase of our product. The manual booklet contains all operation information you may require to install properly and operate the radio remote control system. We hope it will help you to get the most enjoyment of your new control system. Enjoy time with the Avers Screens product. SAFETY INFORMATION NOTICE: Important safety information. Follow the instructions described in the operating manual for safety reasons.
Frequently examine the control system installation for imbalance and signs of wear or damage to cables. Do not use if repair or adjustment is necessary. Watch the moving screen and keep the people away until the screen is completely rolled in/out. It will help to avoid injuries caused with moving screen. All installation work should be carried out by the qualified technician. Improper installation can cause device damage or health breakdown. Do not do anything that may damage the power cables.
2.1 Contents of packaging Please, check carefully if any physical damage of the control system has not happen during transportation. Inspect the package for all accessories presented below: Operation manual x 1 Trigger transmitter x 1 Control unit x 1 2.2 Technical Data Control Unit: Dimensions: 78 x 128 x 45 mm Supply voltage: 220-240V, AC 50Hz Control votage: 220-240V, AC 50Hz Max.
3.3 Electric installation - Lead out the power cables to the place of Control Unit installation. - Control Unit power line should be fused with 3,15A fuse. - Switch off the screen power line during installation work.
!!! CAUTION !!! Some components inside the transmitter and control unit enclosures are under 230V voltage. We recommend to ask qualified electrician to program the control unit and transmitter. Keep highest attention when programming devices to avoid electic shock.
= 4.2 Control system maintenance C12VRC control system do not require periodical service maintenance. Clean dust from the control unit and trigger transmitter cases with dry soft cloths. If needed use moisturized cloth with soft detergent to remove stains. After stain removal dry the cleaned surface with cloth carefully. 4.3 Before calling the service Symptoms Reasons Remedy Screen/lift operates itself Trigger signal was send from another trigger transmitter installed somewhere in the neigborhood.
119 !!! CAUTION !!! Check the holes printed at the template match the location of fixing points at the control unit before you use it. 65 Manufactured after 13.08.2005 This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste.