User's Manual

ManualsBrandsAVerMedia INFORMATION ManualsElectronics300N Wireless LAN INIC Module (IEEE 802.11b/g/n, 2T2R)

1

2

AV3352A Assembly SOP:

1. Insert one AP MODULE

with tilted angle on the AP port(a), and

then push the module

downward (b)

2. Secure the AP module tightly

with two screws

3.

Method to arrange the left antenna: First penetrate the hole

besides DVI connector (red arrow), then lock the other end on the

lower-left corner of the AP module

。

4.

Method to arrange the right antenna: First penetrate the hole

besides phone

jack (yellow arrow), then lock the other end on the

upper-

left corner of the AP module

ENGLISH

with tilted angle on the AP port(a), and

downward (b)

with two screws

Method to arrange the left antenna: First penetrate the hole

besides DVI connector (red arrow), then lock the other end on the

。

Method to arrange the right antenna: First penetrate the hole

jack (yellow arrow), then lock the other end on the

left corner of the AP module

Summary of content (2 pages)

PAGE 1
ENGLISH AV3352A Assembly SOP: 1. Insert one AP MODULE with tilted angle on the AP port(a), and then push the module downward (b) 2. Secure the AP module tightly with two screws 3. Method to arrange the left antenna: First penetrate the hole besides DVI connector (red arrow), then lock the other end on the lower-left corner of the AP module。。 4.
PAGE 2
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.