Installation Instructions

ManualsBrandsAvedro ManualsElectronicsRemote Receiver PCBA, ETR

Manual

Introduction

This module is installed inside the KXL System equipment to receive signals from the remote

control.

The KXL System is an electronic medical device which delivers ultraviolet light (365 nm

wavelength) in a circular pattern onto the cornea after a solution of Riboflavin has been

applied. Irradiating the Riboflavin creates singlet oxygen, which forms intermolecular bonds

in corneal collagen, stiffening the cornea through cross-linking. UV flux and irradiation time

(that is, fluence) at the cornea are controlled by an onboard computer system.

Model : KXL-1B Receiver PCBA

Description : RF remote receiver

Applicant : Avedro

Manufacturer Factory : Hyun seung i&c Co. LTD

RF IC : Nordic semiconductor NRF52810

Communication with KXL system through USB connector (Micro B type).

Input rated : 3.3Vdc

Size : 25.0 X 25.0 [mm] , 1.6T

KXL

System

2.4GHz

I2C

Receiver module

KXL-1B Receiver PCBA is Used only in KHL System.

Summary of content (4 pages)

PAGE 1
Manual Introduction This module is installed inside the KXL System equipment to receive signals from the remote control. The KXL System is an electronic medical device which delivers ultraviolet light (365 nm wavelength) in a circular pattern onto the cornea after a solution of Riboflavin has been applied. Irradiating the Riboflavin creates singlet oxygen, which forms intermolecular bonds in corneal collagen, stiffening the cornea through cross-linking.
PAGE 2
FCC Compliance Notice FCC ID = 2AVGK-KXLRX This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
PAGE 3
Information on test modes and additional testing requirements a) The modular transmitter has been fully tested by the module grantee on the required number of channels,modulation types and modes, it should not be necessary for the host installer to re-test all the available transmitter modes or settings.
PAGE 4
- OEM integrators must ensure that its product is electrically identical to the device, FCC ID: 2AVGK-KXLRX reference designs. Any modifications to module reference designs may invalidate regulatory approvals in relation to the product, or may necessitate notifications to the relevant regulatory authorities. - OEM integrators are responsible for regression testing to accommodate changes to designs, new antennas, and host and submit for C2PC filings.