Owner's Manual

Installation & Assembly

Microwave Oven Bracket Installation Instruction

For use with the following Avanti models:

Microwaves – MO7082MB, MO7191TW, MO7192TB, MO7103SST& MO8003BT

Refrigerators – Can be used with all Compact, Midsize & Counterhigh models except the

SuperConductor models SHP1700W, SHP1701B, SHP1702SS, SHP2403B and SHP2501B

Parts List &

Hardware

Before you start this installation make sure you have all the parts listed below.

Read entire installation sheet before you start assembly of this item.

Part Number

Qty

Description

MOM9704

Mounting Bracket

9704-001

Locking Pin

9704-002

No. 8 x 5/8” Phillips Hex Head

Self Tapping Screw

D 9704-003 4 No. 8 x 1” Phillips Pan Head

Sheet Metal Screw

9704-004

Plastic Anchor (¼” x 1”)

Installation Procedures:

1) Bracket Configuration:

Holes (A), (B) and (C) are the existing holes in the upper part of the Metal bracket. Holes (D), (E), (F) and (G)

are also existing holes in the lower part of the Metal bracket.

See illustration #1.

A B

Illustration #1

2) Installation of the upper side of the Metal bracket to the Microwave:

Place top of the bracket on the back of the microwave. Insert one of the (3) Phillips Hex Head Self Tapping

screws provided into pilot hole (A) then proceed installing the remaining (2) two Phillips Hex Head Self

Tapping screws into holes (B) and (C).Secure using a Phillips head screwdriver.

See illustration # 2.

PAGE 1
Installation & Assembly Microwave Oven Bracket Installation Instruction For use with the following Avanti models: Microwaves – MO7082MB, MO7191TW, MO7192TB, MO7103SST& MO8003BT Refrigerators – Can be used with all Compact, Midsize & Counterhigh models except the SuperConductor models SHP1700W, SHP1701B, SHP1702SS, SHP2403B and SHP2501B Parts List & Hardware A Before you start this installation make sure you have all the parts listed below.
PAGE 2
Illustration # 2 3) Installation of the lower side of the Metal bracket to the Refrigerator: Lay and center the Microwave oven (with bracket installed) on top of the refrigerator. Flip down the lower part of the bracket. Using the four (4) existing holes on the bracket as a guide, mark the locations where to drill the holes (D), (E), (F) and (G). See illustration # 3.
PAGE 3
Illustration # 4 5) Inserting the Plastic Anchors to the Refrigerator: Insert the four (4) Plastic Anchors provided into the four (4) holes (step 5) in the back of the refrigerator. See illustration # 5. Illustration # 5 6) Completing the assembly: Lay the Microwave oven with the metal bracket already installed on top of the refrigerator. Align the four (4) holes of the lower part of the metal bracket to meet the four (4) plastic anchors installed in previous step 6.
PAGE 4
Microwave Oven Lock Pin Refrigerator Illustration # 6 4