Mounting guide
Important warnings Avoid exposing the camera to shocks, high pressure or temperatures above 40oC. Avoid placing the camera near fans, ventilation or other noise sources. This will degrade audio performance. Avoid placing the camera near fans, ventilation, or other heat sources. This will degrade sensor performance. Avoid scratching or leaving fingerprints on the lens, this degrades image quality. If possible, keep the protective plastic on the lens cover during installation.
Safety instructions Prolonged use of the white LEDs may affect sensor readings. This product should be supplied by a Power over Ethernet (PoE) Power Sourcing Equipment (PSE) compliant with IEEE 802.3af or USB-C power source rated 5V 1.5A. The power supply should be UL-listed and marked “Limited Power Source”or “LPS”. The camera and the PoE PSE must be installed within the same building, as described by Environment A of the IEEE 802.3af standard. The PoE PSE must be properly grounded.
Box content Required: • PH2 screw drive • Drill with 6mm (1/4”) drill bit” Hex 2.5mm dh d l d l Screw dimensions Anchor dimensions dh = 9.
Cable routing alternatives Ava Flex • Mounting guide | 5 /1 0
Installing the bracket 1 2 4A Through the wall / ceiling cable 4B Side entry cable 3 Dia: 6mm, [¼”] Depth: 40mm [1.
Attaching the camera and connecting the ethernet cable 5 6 7 Ava Flex • Mounting guide | 7/1 0
Adjusting the ball joint and video stream 8 9 10 Adjust the image orientation in Ava Aware.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
Industry Canada statement This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.