TM THE PE RFORMANCE YOU NE ED Wireless Stereo Headphones Please read this user’s guide before using your new headphones.
Package contents Transmitter Stereo headphones AC adapter 1/8“ (3.5mm) phono adapter User’s Guide 3-foot (91.4cm) RCA cable 1 /4“ (6.3mm) adapter Quick Start Features Completely wireless, with a 150-foot (45.
Adjustable headband Charging connectors Power LED Lights when the headphones are turned on. Power On/Off Volume Back View of Transmitter Front View of Transmitter On/Off Turn the transmitter on or off. AUDIO IN L/R DC 12V Power LED Lights red when the transmitter is turned on. Blinks blue when charging. Lights blue when charged.
2 Install batteries n Note: When using rechargeable batteries, for best AA A AA A 1. Insert three AAA alkaline or rechargeable batteries (neither included), matching the polarity symbols (+ and –) marked inside. AA A charging performance use ONLY NiMH batteries. 2. Switch ALK/RCH to ALK for alkaline or RCH for rechargeable batteries. ALK/RCH w Warning: Never install alkaline batteries with the ALK/RCH switch set to RCH. Alkaline batteries can get hot or explode if you try to recharge them.
3 Charge rechargeable batteries (optional) 1. Turn off the headphones. 2. Make sure rechargeable batteries are installed and ALK/RCH is set to RCH. 3. Dock your headphones on the transmitter in the direction as shown. Make sure the LED on the transmitter blinks blue. Charging connectors L R Charging connectors Line up triangle icons. Power LED Blinks blue when charging. Lights blue when charged. n Note: Charge for at least 20 hours when using new rechargeable batteries for the first time.
4 Use your headphones Select a location which provides the best performance. 1. Press 1to turn on the transmitter. The power LED lights red. 2. Slide Power On/Off to On to turn on the headphones. The power LED lights blue. 3. Set the headphone volume to minimum. 4. Turn on the audio source, and gradually increase the volume to a comfortable level. nNotes: Place your transmitter away from strong light; avoid pointing it at a window where sunlight might prevent optimum reception.
If you connect the transmitter to an audio source headphone jack, set the audio source’s volume to the middle position. Then adjust VOLUME on the headphones to the desired level. Turn off the headphones before turning off the transmitter. This prevents you hearing a loud click that may be generated when you turn off the transmitter. Specifications Transmitter: Carrier Frequency .......................................911.4 and 915.6 MHz Power Source .................................
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
become the property of Ignition L.P. New or reconditioned parts and products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be charged for repair or replacement of the product made after the expiration of the warranty period. IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDITIONS NOT STATED IN THIS LIMITED WARRANTY.
Protect the environment by recycling used electronics. Go to E-CyclingCentral.com to find an electronic recycling center near you. Get more from your audio and video equipment. See what you’ve been missing. With Auvio, you control the experience. Auvio was established by a group of technophiles to provide high quality audio and video products without the high sticker price. The Auvio philosophy is for you to experience audio and video as it was intended to be: pure and distortion free.