AMX 200.
Dear customer, Selecting fine audio equipment, such as the unit you have just purchased, is only the beginning of your musical enjoyment. Now is the time to consider how to maximize the fun and excitement your equipment has to offer.
Introduction Your Autotek MEAN MACHINE amplifier has been designed to give you very high performance, and valuable features, at a reasonable price. Take the time to read over this brief set of instructions, and you will get full enjoyment from your system. Installation The quality of the installation will affect system performance and reliability. You may wish to contact a dealer or professional installer.
fig. 1 Installation of Amplifier Power Supply Connections The +12VDC and ground wires should be heavy gauge standard copper wires with heavy insulation. The wire gauge should be 4AWG for the AMX50.2 and AMX100.2 or larger. In addition, it has a 12V remote control wire and it should be 14AWG-18AWG. It is preferable to have longer speaker wires and shorter power supply wires to minimize power losses. +12V Power This wire is usually connected directly to the positive battery terminal.
Caution First make +12V wire connection then the ground connection and finally the remote connection. Furthermore the +12V wire must always be fused at the battery for protection against possible damage. If you need to replace the power fuse, replace it with a fuse of the same value. Using a fuse of a different type or rating may result in a serious hazard. This amplifier has signal input terminal of RCA connector typ0e for low level inputs.
• • • • • • • The amplifier can be used in the STEREO and BRIDGED mode as shown in Fig. 4, Fig. 5. The speaker wires should be connected to the speaker terminal on amplifier. Notice that most speakers have a polarity marking such as "+" or a dot on speaker terminal and these markings denote the positive terminals of the speaker and are used as a guide to phase the speakers. Improper phasing causes a loss of bass response.
1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. RCA Line Output Jacks Full range output from channel L+R inputs is provided at Line Out Jacks and its output frequency can be adjusted by 3way x-over (HP/FULL/LP.BP) with line out switch. RCA Line Input Jacks It allows left and right inputs to be connected to the amplifier using RCA plugs. Balanced Input Accepts line level balanced input, in the 0.4V to 8V range.
SPECIFICATIONS MEAN MACHINE AMX200.2 *Audio power output per Channel, both channels driven at 14.4VDC -4 Ohms 1kHz 350Wx2CH -4 Ohms Bridged RMS 1200Wx1CH *THD -4 Ohm loads 0.015% -2 Ohm loads 0.15% *Signal to Noise Ratio 100dB *Frequency Response 10Hz-40KHz-1dB *Crossover: Separate -High Pass 10Hz-4.0KHz -Low Pass 10Hz-4.0KHz -Slope 12dB/Stereo, 24dB/Mono -Subsonic Filter 10Hz-150Hz -Bass Boost 0dB-24dB *Input Sensitivity 0.2V-9.
We Want You Listening for a Lifetime Used wisely, your new sound equipment will provide a lifetime of fun and enjoyment. Since hearing damage from loud noise is often undetectable until it is too late, this manufacturer and the Electronic Industries Association's Consumer Electronics Group recommend you avoid prolonged exposure to excessive noise. This list of sound levels is included for your production.
