Product Info

ManualsBrandsAutostar ManualsElectronics24GHz BSD

Page 1 of 6

Overview

WARNING:

To help prevent injuries, never use the Blind Spot Detection

System as a replacement for checking the interior and exterior

mirrors and looking over your shoulder before changing lanes.

The Blind Spot Detection System is not a replacement for careful

driving.

System Overview

The Blind Spot Detection System (BSD) is designed to aid in

detecting vehicles that may have entered the blind spot area, which

is represented by the vehicles in positions 1 & 2 of the diagram

below. The detection area is on both sides of your vehicle, extending

rearward from the exterior mirrors to approximately 50 feet beyond

the bumper. The system is designed to alert the driver if a vehicle

has entered or is present in the blind spot area.

1. Le BSD Area 2. Right BSD Area

Summary of content (7 pages)

PAGE 1
Overview WARNING: To help prevent injuries, never use the Blind Spot Detection System as a replacement for checking the interior and exterior mirrors and looking over your shoulder before changing lanes. The Blind Spot Detection System is not a replacement for careful driving. System Overview The Blind Spot Detection System (BSD) is designed to aid in detecting vehicles that may have entered the blind spot area, which is represented by the vehicles in positions 1 & 2 of the diagram below.
PAGE 2
System Operation System Activation The Blind Spot Detection System (BSD) has a 2 step activation process. If conditions 1 & 2 below are met the system will notify the driver when a vehicle has entered the BSD detection area. 1. The vehicle’s Ignition must be in the ON position. 2. The vehicle must be traveling at speeds above 15m/h. Note: Speed control can be deactivated. See page 4 for more information.
PAGE 3
System Operation Overtaking This type of detection will notify the driver if a vehicle is in the BSD detection area while passing another vehicle. When the target vehicle enters the BSD detection area, the LED indicator will illuminate solid to notify the driver that a vehicle is present. If the vehicle’s corresponding turn signal is activated the LED indicator will begin to flash and the buzzer will sound to warn the driver that a vehicle is present in the BSD detection area.
PAGE 4
Adjustable Settings Volume Control The system Buzzer is equipped with a user selectable volume control; OFF, Low, HI. The volume control switch is located on the buzzer. If the buzzer is not accessible, please contact your authorized installation center. off Lo Hi BSD Sensitivity The BSD sensors can be adjust to Standard or Short Alert Area. This setting can be adjusted to prevent false warnings given to the driver due to a vehicle in the second or third lanes to the left or right.
PAGE 5
System Precautions The system may not correctly operate when any of the following occur: BSD The sensors are blocked. Target vehicles may be traveling too fast or too slow. GPS signal is lost due to poor reception or while driving through a tunnel. RCTA The sensors are blocked. Adjacently parked vehicles or objects are obstructing the sensors. Target vehicles approach at speeds greater than 35m/h. The vehicle speed is greater than 5m/h. You reverse out of an angled parking space.
PAGE 6
Warranty 3 YEAR LIMITED WARRANTY Applies to Audiovox Series Control Modules and Sensors Voxx Electronics Corporation (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, (other than transmitters) under normal use and conditions, be proven defective in material or workmanship within 36 months from the date of original purchase, such defect(s) will be repaired or replaced with new or reconditioned product, (at the Company’s option) without charg
PAGE 7
Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.