Operation Instructions

ManualsBrandsAUTOSLIDE ManualsElectronicsAUTOSLIDE RFID Tag iOpen/K9

Operation instructions

Product name: AUTOSLIDE RFID Receiver iOpen/K9

AUTOSLIDE RFID Tag iOpen/K9

Initial setup

Transmitter must be connected to the door controller and powered up. After power was applied,

blue LED light flashes 3 times. After that the LED is Off.

RFID Tag must have the battery inserted.

Location of main controls

RFID Receiver iOpen/K9

LED indicator

“Learn” button

Relay output

disconnect

Relay output

Normally Open

Relay output

Normally Closed

Summary of content (4 pages)

PAGE 1
Operation instructions Product name: AUTOSLIDE RFID Receiver iOpen/K9 AUTOSLIDE RFID Tag iOpen/K9 Initial setup Transmitter must be connected to the door controller and powered up. After power was applied, blue LED light flashes 3 times. After that the LED is Off. RFID Tag must have the battery inserted.
PAGE 2
RFID Tag iOpen/K9 Tag button Tag LED indicator Introducing new RFID Tag to the transmitter 1. Open the top cover of transmitter unit. 2. Press the hidden button using a pin or screw driver. a. The LED light turns On in Red colour. b. The light indicates the learning mode. Transmitter awaits the signal from the Tag. 3. Bring the Tag into the range of activation (default range is around 2.5m). 4. Red light will start flashing when the signal is received from the Tag. 5.
PAGE 3
Jumper settings selection   Single jumper must be always attached to allow relay operation. If removed, output signal is disconnected. Double switch is used to select the relay contact type: Normally Open (NO) or Normally Closed (NC). Position of each setting is as per illustration. Erasing all Tags from Transmitter memory 1. Remove the top cover of the Transmitter. 2. Access the learning button with the pin or screw driver. Press the button and hold it for 10 seconds or until the red LED is Off.
PAGE 4
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.