Installation Manual
CONTENTS 2
1. TECHNICAL INFORMATION 22.56 inch (570 mm) 3.14 inch (80 mm) 2.25 inch (60 mm) Clip On Safety Cover Side View Front View Features Operator Features and Performance The AutoSwing Automatic Door Operator offers a high standard of performance within a slimline design. • • • • • • • • • The low height of only 2.25 inches (60mm) allows the AutoSwing Operator to be fitted to a transom header.
Components OPERATOR LED Motor Microcomputer Controller Output Axis CLIP ON SAFETY COVER PULL ARM - Inward Opening PUSH ARM - Outward Opening NOTE: AutoSwing comes with either one of the two arms.
INSTALLATION INSTALLATION EXAMPLE Choose pull arm: Door leaf open toward inside (operator is inside) Choose push arm: Door leaf open toward outside (operator is inside) 5
INSTALLATION INSTALLATION OF THE BASE - PULL ARM/PUSH ARM Using a flat screw driver, clip off the safety cover. Plug the power cable into the back of the AutoSwing. Remove the controller by pressing on the two clip on/off buttons.
INSTALLATION INSTALLATION OF THE BASE - PULL ARM Fully close the door. Fix the base on the frame with six countersunk wood screws, (if the frame is steel structure should use M6*15 hex countersunk head screws). use a level throughout this process. Make sure the edge of the base is aligned to the edge of the door. • If installing onto a right hinged door, align the right edge of the base to the right edge of the door.
INSTALLATION - PULL ARM Remove the cover and endcaps of the rail. Keep the door fully closed. If installing onto right hinged door, rotate the arm full to the left. Slide the rail along the ball of the arm. Hold the rail up to the door panel where it will mount. The rail should be flush against the door panel. 1 inch The ball should be upwards in the rail. Position the right edge of the rail an inch from the ball when the door is fully closed Holding the rail in place, drill in the rightmost screw.
INSTALLATION - PUSH ARM FIX THE SUPPORT HOLDER - PUSH ARM Fix the support holder of push arm on the door panel as shown using two round head wood screws. (If the door panel is steel, please use M6*15 cross recessed head screws.) ADJUSTING THE PUSH ARM LENGTH - PUSH ARM (figure 1) 900 L Loosen the four bolts depicted in (Figure 1), and adjust the push arm length according to the door depth (L) until the angle between the push arm and the door panel is 900.
INSTALLATION - PUSH ARM ADJUSTING THE STOPPER POSITION - PUSH ARM Adjust the stopper position in the “U hole” (figure 2) according to the diagram below.
OPERATE THE AUTOSWING BEFORE YOU BEGIN You will need a power point (outlet) near your door to plug in your AUTOSWING unit. POWERING ON AND INITIALIZING Ensure the blue power switch on the right end cap is set to OFF. Configure DIP switch settings as desired. Ensure DIP switch #1 is flipped OFF. (Towards the front of the controller). Using the MODE button, toggle to the Green mode.
OPERATE THE AUTOSWING Turn DIP #1 ON, a blue light will start flashing. Press the learn button, the door should now start to swing open until it hits a jamb or doorstop. Then the door will closes. If the unit has a solid Green mode light the door now is set. By pressing the MODE button, you can toggle between different door settings.
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
To find out more about AUTOSWING, please visit autoslide.