Installation Instructions
Installing your AUTOSLIDE Wireless Hand Wave Sensor or
AUTOSLIDE Wired Hand Wave Sensor
(LSG0 4.5.22)
Installaon
Sensor Port Explanaon
* Note that, if you wirelessly connect your hand wave sensor, you have the opon of switching between “M” (Inside) and “S”
(Outside) channels. Pet Sensor triggering isn’t an opon unless the hand wave is hardwired to the Pet Sensor port. If the hand
wave is hardwired to a specific sensor port, the hand wave’s channel switch is ineffecve.
AUTOSLIDE LLC - autoslide.com - 833-337-5433
The AutoSlide Hand Wave Sensor can be
hardwired or wirelessly connected to the
AutoSlide unit, and offers effortless
tap-to-trigger control. If wirelessly connected,
the hand wave sensor will open the door to
the full default width, but if hardwired to the
unit, it can open the door to a paral pet
width (assuming Pet Mode is programmed).
Check out our video at:
hps://vimeo.com/319406044
- Each sensor requires 2x CR2032 baeries
(included)
- Switch on back switches between Inside
(“M”) and Outside (“S”) sensor connecon
(see picture on le and info below)
- Approx. maximum trigger distance is 4”to
6” from front surface, depending on
brightness of environment
- 4,2” (+12,3”) of cabling included per
sensor
Wireless Installaon
Hardwired Installaon
1. Slide the panel on the back of the sensor down to release it (note: you
don’t need to remove the screw at the top to do this).
1. Go to the back of the hand wave sensor and locate the opening
showing the white port on the sensor’s circuit board (ref. Diagram 1).
2. Insert included baeries into sensor. Each sensor takes 2x CR2032
baeries (one in each slot; “+” side up, grated side down)
2. Take your included sensor cable and plug it into the white port on the
back of the hand wave sensor (ref. Diagram 1).
3. Slide the back panel back into place (make sure to keep the panel’s
rectangular opening above the white port).
3. Locate on your unit’s control panel the ports for “Inside Sensor,”
“Outside Sensor,” & “Pet Sensor” (labeled on the front, ref. Diagram 3).
4. Press the “Sensor Learn” buon on your unit’s control panel. Tap the
hand wave sensor (it should flash blue on the front). Then, press “Sensor
Learn” again, and tap the hand wave again.
4. Take the other end of your sensor cable and plug it into any one of
these three ports (see informaon on which port to use below).
5. The hand wave sensor should now be paired to the unit. Confirm the
sensor is acve by tapping the front of it - it should flash blue on the
front, and open the door.
5. The hand wave sensor should now be connected to the unit. Confirm
the sensor is acve by tapping the front of it - it should flash blue on the
front, and open the door.
1. Connecng the hand wave sensor to the Inside Sensor port will enable it in Green, Red, and Pet Mode.
2. Connecng the hand wave sensor to the Outside Sensor port will enable it in Green and Pet Mode.
3. Connecng the hand wave sensor to the Pet Sensor port will enable it in Pet Mode only.
4. Connecng the hand wave sensor to the Stacker Sensor port will enable it in Blue Mode only.