®/MD OWNER’S MANUAL VW2 (VW2410A) 2016/06 INSTRUCTIONS EN FRANÇAIS AU VERSO
IDATASTART OWNER’S GUIDE 2 WELCOME TO IDATASTART Congratulations on the purchase of your iDataStart VW2 remote start system. Please take a moment to review the following table of contents to help you quicly access the information you need.
IDATASTART OWNER’S GUIDE 3 IDATASTART REMOTE OVERVIEW Your iDataStart VW2 remote start system includes the long-range remote listed below. Please take a moment to familiarize yourself with its general features. TOP LED (TX/RX) CASING RELEASE REMOTE MODEL TR2410A Technology LoRa 2-WAY Max. Range 1 Mile Buttons Transmit Confirmation (TX) Receive Confirmation (RX) Batteries Required Avg. Battery Life Warranty 1 Top LED Top LED 1 x CR2450 8 to 15 months 1 year CUSTOMER SUPPORT: 866.427.2999 / WWW.
IDATASTART OWNER’S GUIDE 4 IDATASTART REMOTE FUNCTIONS & CONFIRMATIONS Thanks to their multiplexing technology, iDataStart remotes can start, stop, lock and unlock your vehicle using only 1 button. Please take a moment to get acquainted with the following functions below: NOTES: 1. Non-highlighted icons = Press & release button 2. Coma (,) between icons = Press buttons one after the other 3. Highlighted (grey) icons = Press & hold button for 2.5 seconds 4. Timeout between each button press = 3 seconds 5.
IDATASTART OWNER’S GUIDE 5 REPLACING IDATASTART REMOTE BATTERIES Follow the steps below to replace the batteries in your iDataStart remotes OR scan the QR code below to view a video tutorial. 1. 2. 3. 4. 5. 6. 7. Insert a 25 cent coin into the hollow (bottom left) corner of your iDataStart remote. Gently twist the coin until the casing pops open. Use your coin to pry open the rest of the case perimeter. Carefully temove the circuit board from the case.
IDATASTART OWNER’S GUIDE 6 ADJUSTING ENGINE RUNTIME SETTINGS Once remote started from your factory key fob or long-range remote, your vehicle will run for the programmed ‘runtime’ setting. The default runtime is 15 minutes but it can also be programmed for 3, 5, 10, 25, 30 or 35 minutes. If you wish to change your remote start runtime setting, contact your iDataStart Authorized Dealer.
IDATASTART OWNER’S GUIDE 7 WHEN SERVICING YOUR VEHICLE To ensure safety during vehicle servicing, the remote starter must be placed in ‘Valet Mode’. The ‘Valet Mode’ will disable remote start functionality. To activate or deactivate the ‘Valet Mode’, follow the instructions below or scan the QR codes to view a video tutorial. With Vehicle Key FUNCTION Valet Mode ON Valet Mode OFF ACTION # OF PARKING LIGHT FLASHES Cycle ignition OFF/ON 2x rapidly, then press brake 3x.
IDATASTART OWNER’S GUIDE 8 REMOTE START TROUBLESHOOTING If your iDataStart remote fails to start the vehicle, the parking lights will flash three times immediately, then flash a number of times according to the errors below: # OF PARKING LIGHT FLASHES DIAGNOSTIC SOLUTION 3+1 Engine is already running Turn engine OFF 3+2 Key in ignition at ON position Remove key from ignition 3+4 Trunk is open Close trunk 3+5 Foot brake is ON Release foot brake 3+6 Hood is open Close hood 3+8 Tach failur
IDATASTART OWNER’S GUIDE 9 VEHICLE SHUTDOWN TROUBLESHOOTING If the remote start sequence has been completed and the vehicle shuts down, the vehicle’s parking lights will flash 4 times immediately, then flash a number of times according to the errors below: # OF PARKING LIGHT FLASHES DIAGNOSTIC SOLUTION 4+1 No engine rev detected Turn ignition ON before trying to remote start 4+3 Foot brake detected Release foot brake 4+4 Hood open detected Close hood 4+5 Engine revving over 3000 RPM Check yo
IDATASTART OWNER’S GUIDE LIMITED LIFETIME WARRANTY Automotive Data Solutions Inc. (“ADS”) warrants to the original purchaser of the iDataStart product that the following components product shall be free of defects in material and workmanship under normal use and circumstances: Control module and installation harnesses For as long as the original purchaser owns the vehicle in which it was originally installed.
IDATASTART OWNER’S GUIDE 11 FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
IDATASTART OWNER’S GUIDE SAR INFORMATION STATEMENT Your wireless REMOTE STARTER (TWO WAY) is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population.
IDATASTART OWNER’S GUIDE 13 In the United States and Canada, the SAR limit for REMOTE STARTER (TWO WAY) used by the public is 4.0 W/kg averaged over 10 gram of tissue. The standard incorporates a substantial margin of safety to give additional protection for the public and to account for any variations in measurements. This device complies with FCC and ISED 10-g extremity SAR requirements when the device is used at 0mm separation.
GUIDE D’UTILISATION IDATASTART 11 CONFORME AUX RÈGLES D’INDUSTRIE CANADA Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radio électrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
10 GUIDE D’UTILISATION IDATASTART GARANTIE À VIE LIMITÉE Automotive Data Solutions Inc.
GUIDE D’UTILISATION IDATASTART 9 DÉPANNAGE EN CAS D'ARRÊT DU MOTEUR Si le moteur s’éteint suite au démarrage à distance, les feux de stationnement clignoteront un certain nombre de fois pour signaler une erreur. Veuillez consulter le tableau ci-dessous pour déterminer la cause de l’erreur ainsi que la solution.
8 GUIDE D’UTILISATION IDATASTART DÉPANNAGE EN CAS D’ERREUR DE DÉMARRAGE Si le véhicule ne démarre pas suite à l’envoi d’une commande de démarrage à distance, les feux de stationnement clignoteront un certain nombre de fois pour signaler une erreur. Veuillez consulter le tableau ci-dessous pour déterminer la cause de l’erreur ainsi que la solution.
GUIDE D’UTILISATION IDATASTART 7 LORS D'UN ENTRETIEN DE VÉHICULE (MODE VALET) Pour éviter que le moteur soit accidentellement mis en marche lors d’un entretien de véhicule ou par un service de voiturier, le démarreur à distance doit être mis en ‘Mode valet’. Pour activer ou désactiver le Mode valet, suivez une des trois procédures ci-dessous ou lisez les codes QR pour voir un vidéo didacticiel.
6 GUIDE D’UTILISATION IDATASTART TEMPS DE MARCHE DU MOTEUR Une fois activé par votre télécommande d’origine ou par votre télécommande longue portée, votre démarreur à distance mettra en marche votre véhicule pour une durée prédéterminée. Par défaut, le réglage du temps de marche est de 15 minutes. Il est possible de changer ce réglage pour une durée de 3, 5, 10, 25, 30 ou 35 minutes. Si vous souhaitez changer le temps de marche de votre démarrage à distance, contactez votre détaillant autorisé iDataStart.
GUIDE D’UTILISATION IDATASTART 5 REMPLACER LES BATTERIES Suivez les étapes ci-dessous pour remplacer les batteries de vos télécommandes iDataStart ou lisez le code QR ci-dessous pour visionner un didacticiel vidéo. 1. 2. 3. 4. 5. 6. 7. Insérez une pièce de 25 cents dans le coin creux (en bas à gauche) de votre télécommande iDataStart. Tournez doucement la pièce jusqu’à ce que le boîtier s’ouvre. Utilisez votre pièce pour soulever le reste du périmètre de la télécommande.
4 GUIDE D’UTILISATION IDATASTART FONCTIONS ET CONFIRMATIONS Grâce à leur technologie de multiplexage, les télécommandes à longue portée iDataStart peuvent démarrer, verrouiller et déverrouiller votre voiture en n’employant qu’un seul bouton. Afin de profiter de vos télécommandes, veuillez vous familiariser avec les fonctions et confirmations ci-dessous: NOTES: 1. Icônes non soulignées = appuyer et relâcher le bouton rapidement 2. Virgule (,) entre les icônes = Appuyez sur les boutons l’un après l’autre 3.
GUIDE D’UTILISATION IDATASTART 3 SURVOL DES TÉLÉCOMMANDES IDATASTART Votre système iDataStart VW2 comprend la télécommande à longue portée ci-dessous. Veuillez prendre un moment pour vous familiariser avec ses caractéristiques générales.
2 GUIDE D’UTILISATION IDATASTART BIENVENUE À IDATASTART Félicitations pour l’achat de votre système de démarrage à distance iDataStart VW2. Veuillez prendre un moment pour examiner la table des matières ci-dessous afin de vous aider à accéder les informations dont vous avez besoin rapidement.
®/MD GUIDE D’UTILISATION VW2 (VW2410A) ENGLISH INSTRUCTIONS ON REVERSE 2016/06