User's Manual

Autoliv Electronics
Lowell Facility
1011 Pawtucket Blvd.
PO Box 1858
Lowell, Massachusetts, USA 01853
The device under test is manufactured by the grantee (Autoliv ASP, Inc.), and sold as an OEM
product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the end-
user has all applicable / appropriate operating instructions. When end-user instructions are required,
as in the case of this product, the grantee must notify the OEM to notify the end-user.
Autoliv ASP, Inc. will supply this document to the reseller/distributor dictating what must be included
in the end user’s manual for the commercial product.
Section 1.01 Information to be included IN the end USER'S MANUAL
The following information (in blue) must be included in the end product user’s manual to
ensure continued FCC and Industry Canada regulatory compliance. The ID numbers must be
included in the manual if the device label is not readily accessible to the end user. The
compliance paragraphs below must be included in the user's manual.
******************************************************************************
Model: 77 GHz MMR FCC ID: WU877MMR IC: 8436B-77MMR
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
WARNING: Changes or modifications not expressively approved by the party responsible for
compliance could void the user's authority to operate the equipment. The term “IC:” before the radio
certification number only signifies that Industry Canada technical specifications were met.
******************************************************************************