Gold Plate Guide

Gold Plate

Guide

Head Balancing

2. If extra counter-balance weight is needed it can be

added by installing a counter-weight on the rear of the

Gold Plate. (A)

1. To balance the head with the camera mounted,

loosen the rod adjustment clamps, the rods will now

slide freely back and forth. When you have achieved a

good balance retighten the knobs, this will secure the

plate in this position.

Counter-balance Weight

2kg/4.4lbs

1. Install the

counter-balance

weight by sliding it

over the two rods at

the rear of the Gold

Plate. Slide the weight

back and forth to

achieve a balance.

2. To lock the

weight in position

tighten the two

clamp screws on

either side.

Additional weights

can be added if

required.

autocue.com

PAGE 1
Counter-balance Weight Head Balancing Gold Plate Guide 2kg/4.4lbs 1. To balance the head with the camera mounted, loosen the rod adjustment clamps, the rods will now slide freely back and forth. When you have achieved a good balance retighten the knobs, this will secure the plate in this position. A 2. If extra counter-balance weight is needed it can be added by installing a counter-weight on the rear of the Gold Plate. (A) 1.
PAGE 2
Components A F B C D E A Rods B Rod Adjustment Clamp C Keyhole Locking Disc D 3/8” BSW Fixing Hole E 1/4” BSW Fixing Hole F Camera Screw 2. Remove the hot shoe from your tripod head and fix it to the underside of the Gold Plate ideally using both 1/4” and 3/8” BSW fixing screws. 3. Replace the Gold Plate on the tripod head ensuring that the keyhole locking discs are facing forward. Assembly Master Series Hood 1.