User's Manual

CHANGING THE TRANSMIT/RECEIVE CHANNELS:
If a number of PC’s are being remotely controlled in the immediate vicinity
(within about 10 meters), interference may occur. This can be overcome by
selecting different channels. Only change the remote control in the event
of interference. To do so proceed as follows:
1. Press and hold the Setup key , until the LED goes out.
2. Release the Setup key. The LED flashes. Now enter the appropriate
code using the numerical keys (1, 2, etc. up to 16).
3. Now press the Setup key briefly. The LED lights briefly, to indicate suc-
cessful programming.
4. Now enter the appropriate code in the Power Cinema Setup program.
BATTERY DISPOSAL
 Important: Batteries are special category waste and must
be disposed of properly. We will be happy to take back
your old batteries. Replace the batteries only with batteries
of the same or an equivalent type.
FCC CAUTION
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
This equipment generates and uses radio frequency energy, and if not installed and
used properly, that is, in strict accordance with the manufacturers instructions, it
may cause interference to radio and television reception. It has been type tested
and found to comply with the limits for remote control devices in accordance with
the specifications in Sub-Parts B and C of Part 15 of FCC Rules, which are designed
to provide reasonable protection against such interference in a residential installa-
tion. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television recep-
tion, which can be determined by unplugging the equipment, try to correct the inter-
ference by one or more of the following measures.
* Reorient the antenna of the radio/TV experiencing the interference.
* Relocate the equipment with respect to the radio/TV.
* Move the equipment away from the radio/TV.
* Plug the equipment into an outlet on a different electrical circuit from the radio/TV
experiencing the interference.
* If necessary, consult your local dealer for additional suggestions.
NOTE: Modifications to this product will void the user's authority to operate this
equipment.
INSTRUCTIONS FOR PC
REMOTE CONTROLLER
Note: This wireless remote control set can only be used to
control the Power Cinema program on your PC. In order
for it to work, the following conditions must be met:
- The PC must be booted up.
- Windows
®
XP must be fully loaded.
- The driver software must be installed*.
- Power Cinema installed*.
- Receiver connected to a USB port.
* All these conditions are met in the delivered state.
INSERTING BATTERIES
1. Turn the remote controller upside down.
2. Open the battery compartment by carefully pulling the clip on the cover
and lifting it at the same time.
3. Insert two batteries (type: AA, Micro) in the battery compartment. Ensure
that the polarity corresponds to the illustration etched on the inside of the
battery compartment
(+ must correspond with + and – with –).
4. Close the battery compartment again.
INSTALLING THE REMOTE CONTROL RECEIVER
It does not matter if the PC is switched on or off when you connect up the re-
mote control receiver.
The necessary driver software is already installed on your computer. The driver
is part of Power Cinema and is installed along with the program.
1. Boot up your PC and wait for Windows
®
to load fully.
2. Insert the USB plug of the remote control receiver in a free USB slot (refer
to your PC operating manual). Your PC will automatically detect the new
device and automatically integrate it provided that the driver has been in-
stalled (delivered state).
3. You can now use the remote controller to operate the Power Cinema program.
S