User's Manual

1
E16STXUS1 guide
E16STXUS1 guide
1Description
2Programming
The transmitting module E16STXUS1 has two groups of DIP switches: a group of 4 and a
group of 8 DIPs. They program some functions and set the working frequency.
The Autec programming set in the other group of four dip switches must never be modified.
The group of eight dip switches located on the radio module are used to program some func-
tions and set the working frequency.
A
connector for interface card or
keyboard
B address key
C DIP switches
D antenna
DIP STATE FUNCTION
1
ON The transmitting unit never switches off automatically
OFF
If the transmitting unit stays switched on without any movement
commands entered, it switches off after approx. 3.5 minutes
2
ON Deactivation of low battery warning from horn on machine
OFF Activation of low battery warning from horn on machine
3
ON
If DIP 8 is OFF automatic scan of the frequencies in the band 915 -
928 MHz
OFF
If DIP 8 is OFF automatic scan of the frequencies in the band 902 -
915 MHz
3-7 ON/OFF If DIP 8 is ON see “Frequency Table”
8
ON
Manual selection mode of the frequencies using DIP 3 - DIP 7 (refer to
“Appendix: Frequency Table”)
OFF
Automatic scan mode of the frequencies in the band selected by DIP 3
(DIP 4 - DIP 7 indifferent)
C
A
B
D