User's Manual

ManualsBrandsAutec ManualsElectronicsTransceiver unit

Original instructions

DYNAMIC SERIES

Part D: CRX receiving unit

INDEX

1 Description ............................................................................................................ 2

1.1 Safety functions of the CRX receiving unit ....................................................... 3

2 Technical data ....................................................................................................... 3

3 Technical data sheet ............................................................................................. 3

4 Plates ..................................................................................................................... 4

5 Light signals .......................................................................................................... 4

5.1 POWER LED (green) ....................................................................................... 4

5.2 ALARM LED (red) ............................................................................................ 5

5.3 RUN LED (green) ............................................................................................. 5

5.4 ERR LED (red) ................................................................................................. 5

6 Malfunction signalled by the receiving unit ........................................................ 6

AUTEC LICRXE00-01

Summary of content (8 pages)

PAGE 1
Original instructions Dynamic Series Part D: CRX receiving unit Index 1 Description ............................................................................................................. 1.1 Safety functions of the CRX receiving unit ........................................................ 2 Technical data ........................................................................................................ 3 Technical data sheet ..................................................................
PAGE 2
Description 1 Description A mounting holes F Connector for cable control B LED G Plug or cable gland C IDK connector (for address key) H D DIP switches BNC connector for external antenna kit (optional) E DTK connector (for memory board) J Fuse F1 K Technical data plate L Radio remote control identification plate LICRXE00-01 AUTEC - Dynamic Series
PAGE 3
Technical data 3 The receiving unit is interfaced with the machine through the outputs and their wiring and/or through a CAN network (of which it is a slave node). The CAN communication of the CRX receiving unit can be enabled or disabled. The machine manufacturer or who install the radio remote control on the machine determines whether the CAN communication is enabled or disabled. The STOP and SAFETY outputs are some of the receiving unit's outputs. 1.
PAGE 4
4 Plates Plates The receiving unit has the following plates: Plate radio remote control identification plate technical data plate 5 Position Content On the casing of the receiving unit Radio remote control serial number (S/N), bar code and manufacturing year. On the casing of the receiving unit MODEL, TYPE and main receiving unit technical data, marking and possible radio remote control marks.
PAGE 5
Plates 5 5.2 ALARM LED (red) The ALARM LED warns about anomalies in the receiving unit. The ALARM LED... …is off Meaning The receiving unit works correctly. ... blinks once Error on the SO1 and SO2 outputs when configured as STOP outputs. ... blinks twice Error on the SO1 and SO2 outputs when configured as SAFETY outputs. ... blinks three times ... is on Error on the outputs corresponding to direction commands. Configuration error on the SO1 and SO2 outputs (see paragraph 1.1). 5.
PAGE 6
Malfunction signalled by the receiving unit 6 Malfunction signalled by the receiving unit Use the light signals on the receiving unit to identify the radio remote control malfunction. If the problem persists after the suggested solution has been carried out, contact the support service of the machine manufacturer. Signals Possible reason Solutions The POWER LED is off. The receiving unit is not powered.
PAGE 7
PAGE 8