User's Manual

Document No. 80006.2 Copyright 2008, Autani Corporation. All rights reserved.
Switched Lighting Control Module
Specifications
Power:
SLC: 24VDC
Power Pack: 120/277VAC Input, 24VDC output, 20Amp
switching load capability
Operating Temperature:
Nominal ambient temperature of 25 degrees Celsius
Wireless Communications:
2.4 GHz, 16 channel spread spectrum
Operating Temperature:
The rated loads are in accordance to an ambient temperature of
25 degrees Celsius
This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference
and, 2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes of modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This Class B digital apparatus complies with Canadian ICES-003.
UC:7737A-SLC1000105
FCC ID:V8NSLC1000105
This device is not UL Listed.
Product code: 1000105
Overview
The Switched Light Controller (SLC) along with the Autani
Energy Manager provides a complete, expandable Energy
Efficiency System for the commercial building industry. The
SLC system consists of the SLC, wall switch(s), Power Pack
and motion sensor(s). A functional diagram is shown below.
One SLC can control one or two independent switch circuits,
of any type: single, two way, three way or four way. Multiple
motion sensors can be wire-OR together to enhance coverage,
all from a single channel on the SLC. Different sensor
profiles are available, from wide angle to narrow sensitive
motion detection. The switch(s), motion sensor(s) and
control signals to the Power Pack are all low voltage.
Autani Corporation
7125 Columbia Gateway Drive
Suite 200
Columbia, MD 21046
Phone: [phone]
Web: www.autani.com
Email: [e-mail]
Technical Support
If you have questions about the installation or operation of this
device, call Autani technical support at: 443-320-2233
Warning! There are no serviceable parts within the SLC and no
attempt should be made to disassemble the device.
Warning! Improper connection of the device may result in
permanent damage to the device. Follow installation
instructions carefully.
Caution! Using this product in any manner other than outlined
in this document is not supported and voids any warranty.
Autani is not responsible for any damages or injuries incurred
as a result of misuse or abuse of this product.
Device Installation
The branch circuit should be turned off before any installation is
started. If this is an upgrade the existing wiring can be utilized
as needed as long as all codes are followed. The SLC can be
mounted on an interior wall or above the ceiling as long as it is
accessible if needed. Wiring to and from the SLC is all low
voltage. Follow the manufactures directions for installing the
Power Pack. It is recommended that a licensed electrician install
the Power Pack. The motion sensors are designed to be mounted
on the typical one inch wide channel for drop ceilings. The RJ-
11 connector on the motion sensor plugs into the female socket
on the cable run from the SLC. See the wiring table below for
connecting the SLC to the other components as required.
SLC identification: