INSTALLATION AND OPERATION MANUAL ICON-CP
IMPORTANT SAFETY INFORMATION PRÉCAUTIONS DURANT UTILISATION 1. Read these instructions. 1. LISEZ ces instructions. 2. Keep these instructions. 2. Tenez ces instructions. 3. Heed all warnings. 3. Notez tous les avertissements. 4. Follow all instructions. 4. Suivez toutes les avertissements. 5. Do not use this apparatus near water. 5. N’utilisez pas ce produit près de l’eau (la piscine, la plage, le lac, etc.). 6. Clean only with dry cloth. 6. Nettoyez seulement avec une étoffe sèche.
INTRODUCTION AND CONTENTS ICON-CP INTRODUCTION 3 The ICON control panel is both elegant and ergonomic to suit today’s modern installations. ICON-CP AND REVOLUTION SERIES 4 The ICON CP controls a number of Australian Monitor products & will also be compatible with a number of new products making the unit flexible and future proof.
ICON-CP AND REVOLUTION SERIES The Revolution series control panels (ICON-CP) have two banks of DIP switches on the rear of the control panel. The first bank of switches labeled SW1 allows the user to address the panel for RS485 communications. The second bank of switches allows the user to set up the LED functions for the remote panel. SW1: RS485 addresses 1-240 are allowed. With any other address the unit will blink its error LEDs.
ICON-CP AND AMD100-200 The ICON-CP can be used to control certain functions of the AMD100/200. The set up the control panel all you need to do is address the panel on SW1. Switch 1-8 represent a binary address. For example to address it to ID1 all you need to do is have number 1 on, to address it to 3 have switch 1 and 2 on. 1. BGM 1 SW2 C and D do not do anything, A and B adjust the LED settings of the panel. With switch A high ambient light adjustment will be turned on.
ICON-CP AND IN600 With the ICON-CP’s DIP switch bank 2(FUNC) set with D on the ICON-CP will control the AMAV IN600. The control parameters are fixed to three different configurations. These are: 1. Source 1 (DVD1) 2. Source 2 (DVD2) 3. Source 3 (AUX1) Address ID 1: (Switch 1 On) With this setting you get control over selection of the sources and also volume control of the source mixer. When a source is selected after already being active the unit will switch the source to “Off” 4. Source 4 (AUX2) 5.
DIMENSIONS ICON-CP MANUAL PAGE 7
ENGINEERED BY AUSTRALIAN MONITOR Address: 1 Clyde Street, Silverwater, Sydney NSW 2128 Australia. Private Bag 149, Silverwater NSW 1811 ABN 78 001 345 482 Website: www.australianmonitor.com.au International enquiries email: international@australianmonitor.com.au DISTRIBUTED IN AUSTRALIA AND NEW ZEALAND BY HILLS SVL www.hillssvl.com.au NSW P: 02 9647 1411 E: nsw@hillssvl.com.au QLD P: 07 3852 1312 E: qld@hillssvl.com.au ACT P: 02 6260 4544 E: act@hillssvl.com.au WA P: 08 9204 0200 E: wa@hillssvl.com.
