User's Manual

ManualsBrandsAurum Electronics ManualsElectronicsTHE INTELLIGENT MOTION SENSOR TRACKING LIGHT-Light

THE INTELLIGENT MOTION SENSOR TRACKING LIGHT

INSTALLATION INSTRUCTIONS

Read all instructions before proceeding with the installation

OVERVIEW OF AEC-9331CU-SP8

IMPORTANT: THE INTALLATION OF THIS FITTING MUST BE DONE BY A QUALIFIED ELECTRICIAN.

 This fitting must be earthed.

 Do not mount the luminaire against inflammable surfaces.

 The motion detector will not operate correctly if it is installed:

( ) Near the outlet of a central heating boiler Ⅰ

( ) Near air conditioning plant Ⅱ

( ) Pointing directly at moving vehicles Ⅲ

( ) Within sight of reflection from moving water Ⅳ

( ) Where other lamps could shine onto the detectorⅤ

NOTE:

* This highly responsive unit may occasionally activate due to rapid environmental changes. Allow for approximately

30 seconds warm-up time before the sensor resumes normal activity.

* Please make sure the voltage and polarity are correct before connection. Incorrect voltage may cause electric shock.

If you are not sure, please contact your retailer.

* Do Not remove the tape until your finish the installation. If the tape comes off the light, please replace it or hold the

light head to avoid swiveling and damage the product.

MOUNTING THE FITTING

To ensure correct operation of the sensor, mount the luminaire that traffic passes across the detector.

WARNING ! ! !

BEFORE ATTEMPTING ANY INSTALLATION OR

MAINTENANCE, ENSURE THAT THE

ELECTRICAL SUPPLY IS SWITCHED OFF AND

THE CIRCUIT FUSES REMOVED OR THE

CIRCUIT BREAKER IS IN THE “OFF”POSITION.

TOP

GOOD SENSITIVITY LESS

Summary of content (5 pages)

PAGE 1
THE INTELLIGENT MOTION SENSOR TRACKING LIGHT INSTALLATION INSTRUCTIONS Read all instructions before proceeding with the installation OVERVIEW OF AEC-9331CU-SP8 IMPORTANT: THE INTALLATION OF THIS FITTING MUST BE DONE BY A QUALIFIED ELECTRICIAN. This fitting must be earthed. Do not mount the luminaire against inflammable surfaces.
PAGE 2
SETTING THE LIGHT UP TIME & SENSITIVITY Remove the back mounting box from the fixture by unscrewing the screw at the bottom. Set the Light up time & Sensitivity you preferred １： Light activation time (OFF： 30 seconds／ ON： 60 seconds) ２： Light Sensitivity (OFF： 5m／ ON： 10m) Re-fit the back mounting box and tighten the screw. INSTALLATION AND WIRING INSTRUCTIONS Remove the existing light fixture. Install crossbar lower plate as shown with two screws. Do not completely tighten central screws.
PAGE 3
FUNCTION This light is equipped with 3 motion sensors: zone 1 covers 60 degree, zone 2 covers 100 degrees and zone 3 covers 60 degrees. 220 degrees (maximum) in total for 3 zones. ZONE 2 ZONE 1 ZONE 3 TOTAL DETECTION RANGE The light will switch on for 30 /60 seconds and off automatically when heat/ movement is detected. The factory default: the mode is「Nighttime Mode」for light works at night, camera works all day.
PAGE 4
Left 70° Right 70° Hidden LED indicator OPERATION 1. Turn on the wall switch to activate the fitting, the fitting is now under Nighttime mode: light works at night and camera works all day. You will be able to view what the camera sees with the handheld LCD Monitor. The camera operates 24 hours a day and is not controlled by the PIR sensors. NOTE: Allow for approximately 30 seconds warm-up time before the sensor resumes normal activity. 2. To test, walk through the sensor’s detection area. 3.
PAGE 5