User's Manual

ManualsBrandsAurum Electronics ManualsElectronicsDigital Wireless TV receiver

AEC-707C

DIGITAL WIRELESS TV RECEIVER

Noted the receiver will combine with digital camera fitting to use; Please Read all instructions

before proceeding with the installation

I. OVERVIEW

II. ASSEMBLY INSTRUCTIONS

1. Connect the receiver to a Monitor/TV with AV cable. (yellow for video and red for audio, but audio is not available

here)

2. Connect the adapter to the receiver. (DC 6V 0.5A).

3. Push the power switch to ON position and the LED indicator lights up

MENU Button

OK Button

Channel

Button

Buzzer

Antenna

Video Output

Power Socket

View Button (1/4)

(Single/Quad)

LED indicator

Power switch

Summary of content (4 pages)

PAGE 1
AEC-707C DIGITAL WIRELESS TV RECEIVER Noted the receiver w ill combine w ith digital camera fitting to use; Please Read all instructions before proceeding w ith the installation I. OVERVIEW Antenna MENU Button OK Button Video Output Channel Button Buzzer View Button (1/4) (Single/Quad) Power Socket Power switch LED indicator II. ASSEMBLY INSTRUCTIONS 1. Connect the receiver to a Monitor/TV with AV cable. (yellow for video and red for audio, but audio is not available here) 2.
PAGE 2
4.Power on the Monitor/TV and select AV mode. 5. Set the channel of the receiver to the same as that of camera fitting by pressing the channel button continuously and then you can see the camera image displayed on the connected Monitor/TV. This receiver can be paired with up to four camera fitting. - Press “MENU Button” then press Channel Button to select “MONITOR” and press “OK button”. - Press “Channel Button” to select ”Pair Cam” and then press “OK button”.
PAGE 3
IMPORTANT OPERATION OF TV RECEIVER 1. LCD image display： push view button「1/4」for image display -Single View： single CAMERA view (initial image) display image from one camera at one time This is only for connecting 1 CAMERA. For connecting several CAMERAS, make sure to return to quad-view after finishing setting in single view.
PAGE 4
-MONITOR： Beep：ON/OFF(original default ON) Beep Vol：High/Low(original default High) OSD Disp：ON/OFF View Mode：AUTO/MENU( original default AUTO) Scan time：OFF/5SEC/10SEC/15SEC (original default OFF) Pair Cam：1/2/3/4 When SENSOR detects motions, monitor will beep.