User's Manual

ManualsBrandsAurum Electronics ManualsElectronicsThe Intelligent Motion Sensor Tracking Light (Transmitter)

THE INTELLIGENT

MOTION SENSOR TRACKING LIGHT

INSTALLATION INSTRUCTIONS

Read all instructions before proceeding with the installation

OVERVIEW OF AEC-9336B

INSTALLING THE BULB

 Unscrew the lamp cover of the luminaire and install a

150W J-type lamp.

 Re-fit the lamp cover and tighten the screws.

SETTING THE CHANNEL

 Remove the back mounting box from the fixture by

unscrewing the screw at the bottom.

 Set the channel you preferred

 Re-fit the back mounting box and tighten the screw.

IMPORTANT: THE INTALLATION OF THIS FITTING MUST BE DONE BY A QUALIFIED ELECTRICIAN.

 This fitting must be earthed.

 Do not mount the luminaire against inflammable surfaces.

 The motion detector will not operate correctly if it is installed:

( ) Near the outlet of a central heating boiler Ⅰ

( ) Near air conditioning plant Ⅱ

( ) Pointing directly at moving vehicles Ⅲ

Push-button

3 motion sensors

WARNING ! ! !

BEFORE ATTEMPTING ANY INSTALLATION OR

MAINTENANCE, ENSURE THAT THE

ELECTRICAL SUPPLY IS SWITCHED OFF AND

THE CIRCUIT FUSES REMOVED OR THE

CIRCUIT BREAKER IS IN THE “OFF”POSITION.

Channel 1 Channel 2 Channel 3 Channel 4

(DRAFT)

Summary of content (4 pages)

PAGE 1
THE INTELLIGENT MOTION SENSOR TRACKING LIGHT (DRAFT) INSTALLATION INSTRUCTIONS Read all instructions before proceeding with the installation OVERVIEW OF AEC-9336B Push-button 3 motion sensors INSTALLING THE BULB Unscrew the lamp cover of the luminaire and install a 150W J-type lamp. Re-fit the lamp cover and tighten the screws. SETTING THE CHANNEL Remove the back mounting box from the fixture by unscrewing the screw at the bottom.
PAGE 2
(Ⅳ) Within sight of reflection from moving water (Ⅴ) Where other lamps could shine onto the detector The maximum rating of this luminaire is 150 Watts. Check that the total load of the circuit. Including this luminaire. Does not exceed the rating of the circuit cable. NOTE: This highly responsive unit may occasionally activate due to rapid environmental changes. Allow for approximately 30 seconds warm-up time before the sensor resumes normal activity.
PAGE 3
Check that all connections are correct and tight, as any misconnections will damage the detector. Re-fit the fitting to the back mounting box. FUNCTION This light is equipped with 3 motion sensors: zone 1 covers 60 degree, zone 2 covers 100 degrees and zone 3 covers 60 degrees. 220 degrees (maximum) in total for 3 zones. ZONE 2 ZONE 1 ZONE 3 TOTAL DETECTION RANGE The light will switch on for 3 minutes and off automatically when heat/ movement is detected.
PAGE 4
OPERATION 1. Turn on the wall switch to activate the light, the light is now under All Day mode: light works on day and night NOTE: Allow for approximately 30 seconds warm-up time before the sensor resumes normal activity. 2. To test, walk through the sensor’s detection area. 3. Movement will activate the sensor and turn the light on, the light will turn the face to the detected zone for approx. 3 minutes. 4.