▲Flight B2S Design guide
1、Summarize Flight B2S offers a highly integrated wi-fi solution featuring compact design, reliable performance, and versatility. In addition to the wi-fi capabilities, Flight B2S also integrates with the Hi3518V300 series of processors for powerful processing power. Flight B2S enables GPIO port, serial port and other integrated sensors and other devices to reduce the early development costs and minimize the use of system resources during operation.
2、 Functional description technical indicator parameter Sensor Type 1/3" CMOS Sensor pixel 2Mega minimal illumination Colours 0.01Lux@F1.2 Monochrome 0.001Lux@F1.2 Lens 4.0mm F2.0 shutter 1/25 s~1/100,000 s Infrared ligh ICR Infrared filter Wide Dynamic Digital WDR video compression standard H.
3、 Layout
4、Flight B2S interface specification 4.1 power interface JP1(1.25 spacing) 4.2 Pin number function 1 GND 2 5V 3 GND 4 12V IR_CUT interface JS11(1.25 spacing) Pin number 4.3 4.4 function 1 Ircut negative electrode 2 ircut positive electrode audio input JS8(1.25 spacing) Pin number function 1 MIC positive 2 MIC negative audio output JS9(1.25 spacing) Pin number function 1 speaker positive 2 speaker negative 4.5 infrared lamp control interface JL1(1.
（ACTIVE low） 4.8 3 Reserved IO GPIO7_0 4 Reserved IO GPIO6_7 5 GND 6 3V3 external communication interface JS13(1.25 spacing) Pin number primary function 1 2 3 4 5 6 4.9 Alternate Function VCC（3V3 or 5V） I2C2_SDA GPIO4_4 I2C2_SCL GPIO4_4 GND URAT1_RX GPIO6_0 UART1_TX GPIO6_2 Seventh, SD card external expansion interface JS15(0.
10. OEM/Integrators Installation Manual 10.1. List of applicable FCC rules This module has been tested and found to comply with part 15.247 requirements for Modular Approval. 10.2. Summarize the specific operational use conditions This module can be used in Wifi-camera. The input voltage to the module should be nominally 4.75-5.25 VDC ,typical value 5VDC and the ambient temperature of the module should not exceed 50℃. Flight B2S has one PCB antenna with max antenna gain 2.5dBi . 10.3.
10.7. Label and compliance information When the module is installed in the host device, the FCC ID/IC label must be visible through a window on the final device or it must be visible when an access panel, door or cover is easily re-moved. If not, a second label must be placed on the outside of the final device that contains the following text: “Contains FCC ID: 2ANJC-FLIGHTB2S” “Contains IC: 25656-FLIGHTB2S“ The FCC ID/IC can be used only when all FCC ID/IC compliance requirements are met. 10.8.
devices or drivers are not available. When testing for emissions from the unintentional radiator, the transmitter shall be placed in the receive mode or idle mode, if possible. If receive mode only is not possible then, the radio shall be passive (preferred) and/or active scanning. In these cases, this would need to enable activity on the communication BUS (i.e., PCIe, SDIO, USB) to ensure the unintentional radiator circuitry is enabled.
