Install Smart Lock Pro, 3rd Gen Technology What’s in the box What you’ll need to provide
1. Prepare your existing deadbolt Use the supplied adhesive strip to hold the keyed side of the lock in place.
2. Remove your existing thumb-latch Unscrew and remove the screws from your existing deadbolt thumb-latch. If there is an additional back plate, remove that as well. Be sure to unlock your deadbolt before removing the thumb-latch entirely.
3. Prepare the Mounting Plate The included mounting plate has two adjustable screw-holes that can be repositioned as needed. Remove the screws from the thumb-latch and insert them into the front of the mounting plate.
4. Attach the Mounting Plate Tighten the screws by hand until the mounting plate is settled securely against the door.
5.
Select your adapter from the Compatibility Chart above. If your lock brand is not in the chart, slide each adapter onto the tailpiece to find the right one. The correct adapter will have the small nub pointing up. NOTE: The adapters can be placed in the mounting plate backwards. So if the shape is correct, but it seems backwards, try flipping the adapter around.
6.
7. Open the wing latches Pull out both side wing latches to prepare for mounting.
8. Attach the August Smart Lock Pro Slide the August Smart Lock Pro over the tailpiece and attach it to the mounting plate. Make sure the back of the lock is flush with the door. To secure the August Smart Lock Pro, clamp down both side wing latches to the mounting plate completely.
9. Remove the faceplate Press down on the August logo located at the bottom of the face plate. Grab the top of the faceplate and remove it.
10. Remove the battery tab While holding the batteries in place, remove the plastic battery isolation tab. Make sure that the battery is properly seated in its compartment.
11.
12. Install DoorSense™ DoorSense™ enables your lock to know when the door is open and closed. For instructions on installing DoorSense™, please see: DoorSense™ Installation Guide for August Smart Lock Pro 13. Use the August Home app to complete setup Download and install the August Home app. Select "Get Started" from the home screen, or, if already logged in to the app, select "Set Up a Lock" from the main menu.
Deadbolt Parts The thumb-latch (or thumbturn) is the part of your deadbolt inside your home that you use to lock and unlock your deadbolt. The deadbolt is the piece of the lock that secures your door shut.
The turnpiece (also known as a tailpiece) is the portion of your lock that extends through your door from the outer key cylinder to the inside of your door. The thumb latch connects to turn piece in order to operate your lock. Your August lock will attach to this in place of the thumb latch. The keyhole is where your keys operate your deadbolt.
None of the mounting plates fit the screws for my lock If you would like to confirm if your deadbolt is compatible with August, please check the compatibility diagrams or send a picture of both sides of the lock, and a side view of your door to photos@august.com.
