entry pad QSG front and back Model: AK-R1 Questions? If you have any questions, call 844-AUGUST1 (284-8781) or visit august.com/support Getting Started Photo FPO ©2015 August Home Inc.
entry pad QSG inside spread For detailed installation instructions visit august.com/install Install Smart Lock Follow the installation instructions that are included with the Smart Lock to replace your existing thumb-latch. 1 Install Smart Keypad 1 Simply screw the mounting plate on your wall. 2 Remove the plastic battery tab. 3 Easily clip Smart Keypad onto the mounting plate.
Safety Risk of explosion and personal injury if device is installed into non compatible circuit. Do not open, mutilate, or expose to conducting materials (metal), moisture, liquid, fire or heat above 54° C (130° F), incinerate, or immerse in water or liquid of any kind. Do not short circuit. Doing so may cause batteries to leak or explode, resulting in personal injury. The August Doorbell Cam must be correctly installed and used with a wired doorbell circuit that is operating in good condition.
Terms and Conditions
Limited Warranty Statement IMPORTANT: By using the August Doorbell Cam hardware (the “Device”) you are agreeing to be bound by the terms of this Limited Warranty set forth below.
4. Scope of and Limitation of Warranty. The warranty on this Device is limited to the repair or replacement of defective Devices as described in the Limited Warranty section above. This warranty does not cover customer training and education, installation, set up or adjustment, signal or reception problems. The August Doorbell Cam (statement about certification or not) must be correctly installed and used with an existing doorbell circuit that is operating in good condition.
Compliance FCC INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.