User Manual

TM 1

TEST & MEASUREMENT MICROPHONE

TM 1

Test and Measurement Microphone

FEATURES:

6mm pre-polarized condenser capsule

Hi SPL response

Precision machined brass housings

Low noise electronics

Replaceable electronics and capsule

3 year warranty

APPLICATIONS:

Test and measurement

Real time analyzers

Room analysis software programs

Ambient room miking

OVERVIEW:

The TM1 is a 6 mm pre-polarized condenser microphone used for test

and measurement applications. The TM1 is known for its linearity,

accurate response, consistency, ease of use and aordability.

Characterized with a uniformly controlled omni-directional polar pattern,

the TM1 is designed to capture acoustic measurements for room

analysis software programs, real time analyzers and other sound control

devices. With a at frequency range of 20 Hz – 25 kHz, the TM1 is an

excellent tool for sound engineers, sound companies, and recording

enthusiasts.

Requiring 18 - 52 Volts phantom power for operation, the TM1 features

a precision machined 4-stage brass body and capsule housing, nickel

plate nish, Switchcraft ® XLR, shock absorbent O-rings, and heavy duty

snap to t mic clip.

SUPPLIED ACCESSORIES:

Heavy duty tension fit mic clip (DCLIP)

Carrying pouch (P1)

OPTIONAL ACCESSORIES:

WS-TM1 - Screw-on windscreen

TRIPOD - Tripod mic stand

MC19 - Shockmount clip

CBL-20 - 20’ XLR-XLR quad conductor mic cable

WS-TM1 DCLIP MC19 CBL-20 TRIPOD

PAGE 1
Test and Measurement Microphone TM 1 TEST & MEASUREMENT MICROPHONE OVERVIEW: The TM1 is a 6 mm pre-polarized condenser microphone used for test and measurement applications. The TM1 is known for its linearity, accurate response, consistency, ease of use and affordability. Characterized with a uniformly controlled omni-directional polar pattern, the TM1 is designed to capture acoustic measurements for room analysis software programs, real time analyzers and other sound control devices.
PAGE 2
Pre-polarized Condenser 20 Hz - 25 kHz +/-2dB Omni 200 ohms 6.5mV / Pa @ 1k 130 dB with distortion < 1% 140 dB Max Signal to Noise Ratio 66 dB Equivalent Noise Level 28 dB (A weighted) Dynamic Range 112 dB Power Requirements 18-52 Volts phantom Connector Switchcraft® male XLR Polarity Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector Housing 4 piece precision machined brass Finish Nickel Length 150 mm / 5.