Name: E-mail address: Telephone number: Created on (date): Current issue level Issue date: Ian Briggs ian.briggs@bentley.co.uk +447507889462 28/04/2014 1.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 LIST OF CONTENTS List Of Contents Revision History Abbreviations and Definitions used in this Document Confidentiality and Security 1.1 Feature Description 1.1.1 General Overview 1.1.2 Component Description(s) 2 Installation Requirements 2.1 RSE Control Unit 2.1.1 General Information 2.1.2 Installation 2.1.3 Removal 2.2 DVD Loader unit 2.2.
Bentley Rear Seat Entertainment System Installation Manual REVISION HISTORY Version V1 Issue date Reason for change Initial Version 2 Issue 1.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 ABBREVIATIONS AND DEFINITIONS USED IN THIS DOCUMENT The following table lists the terms used in this document. Term Definition The following table lists the abbreviations used in this document.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 CONFIDENTIALITY AND SECURITY The information contained within this Specification is of a confidential nature and a Confidentiality Agreement must exist between our companies before you may examine any part of this document. If you are not aware of any such agreement you must seek an Agreement without delay by contacting the undersigned.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 1. Access to the internet via a 3G UMTS module (Package protection to be included for LTE module as part of design). User accessible SIM slot. 2. Use of the system as an in-car Wi-Fi hotspot for up to 5 devices. 3. The ability to listen to music in the vehicle using the vehicle speakers and/or headphones. 4. The ability to connect 3rd party devices to use the internet 5. The ability to listen to internet radio 6.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 2 INSTALLATION REQUIREMENTS 2.1 RSE CONTROL UNIT In order to meet the legislation for the FCC & IC requirements the system needs to have some minimum separation distances from the surface that the user could touch for the SAR regulations. CAUTION: FCC REGULATORY REQUIREMENTS This device complies with Part 15 of the FCC Rules.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 For GSM / UMTS: Smarteq Antenna AB; part No: 3W7.035.524.A For Bluetooth / WLAN: WISI Automotive GmbH & Co. KG; part: Wisi AG91 WLAN Bentley 4W0.962.131 The equipment is installed to ensure a minimum 20 cm distance between the two antennas and, with a minimum safe operating distance of 20 cm between the respective antennas and the car occupants.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 2.1.1 GENERAL INFORMATION The Control unit 2 for information electronics -J829- -arrowed- is located inside the glove box on the outboard side. Note Image shows a right hand drive vehicle. Left hand drive vehicle is a mirror image. Replacement control units require additional programming via the Vehicle tester. Refer to Installation instructions.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 2. Vehicle tester Torque tightening values Unless otherwise shown, standard torque values apply. → Rep.-Gr.00 Figure 3 Vehicle tester 2.1.2 INSTALLATION 1. Ensure all electrical connectors are connected correctly. 2. Insert the unit into the slot in the Glove box. 3. After installation ensure the catches secure the control unit on both sides.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 2.1.3 REMOVAL The following procedure is based on a right hand drive vehicle. The procedure is the same for both left hand and right hand drive. 1. Switch off the ignition 2. Insert the removal tools WT 3. 10221- into the slots in the control unit until they locate Note Ensure that both tools click into position before attempting to remove the control unit.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 Disconnect the harness connectors -1- and remove the control unit -2- from the vehicle. Figure 7 RSE Control Unit - Removal of Electrical Connectors 2.2 DVD LOADER UNIT In order to meet legislation for the FCC & IC requirements the system needs to have some minimum separation distances from the surfaces that the user could touch for the SAR regulations.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 2 - This device must accept any interference, including interference that may cause undesired operation of the device. Any change or modification to the product not expressly approved by the manufacturer could void the user's authority to operate the device. IC RF Radiation Exposure Statement: This equipment contains a radio transmitter.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 Figure 8 Minimum required separation distances required to be maintained between Antenna and Body or Limbs 2.2.1 INSTALLATION GUIDE Installing the DVD loader as per this guide will ensure that the minimum distances as mentioned in Figure 8 are met. Connect the harness connections prior to refitting the DVD loader to the front seat squab. Torque tighten all fixings.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.2 - 28/04/14 Figure 9 DVD Loader Unit Installation – Mounting to map pocket Connect the DVD loader unit harness connections to the leads coming off the seat as shown in Figure 10. Figure 10 DVD Loader Unit Installation - Harness Connection Offer the DVD Loader Unit and map pocket to the seat and slide upwards to engage the catches at the side inserting the 3 fixings as shown in Figure 11.
Bentley Rear Seat Entertainment System Installation Manual Issue 1.