By AMS690H / AMS680H / AMS620H / AMS525H / AMS460H / AMS400H / AMS352H OWNER’S MANUAL
FEATURES & SPECIFICATIONS FEATURES Carbon Injection Cone Butyl Rubber Surround 2 Layer High-Temp ASV Voice Coil 4 Ohm Impedance Polyswitch Tweeter Protection Circuit Standard and Custom Grilles 4” and Up Complete with Mounting Hardware POWER HANDLING ACHIEVABLE POWER AMS690H: 175 Watts RMS AMS680H: 85 Watts RMS AMS620H: 80 Watts RMS AMS525H: 70 Watts RMS AMS460H: 60 Watts RMS AMS400H: 60 Watts RMS AMS352H: 40 Watts RMS FREQUENCY AMS690H: AMS680H: AMS620H: AMS525H: AMS460H: AMS400H: AMS352H: 25Hz-20kH
Choosing A Location It is always best to plan the complete installation prior to attempting to install any product . The routing of wires, power connections and mounting locations should be planned first. As with any car stereo installation, and all work performed should be checked thoroughly and carefully prior to the operation of the system. The placement of your Audiobahn speakers within your vehicle will greatly affect the overall performance of your audio system.
Installation Installation NOTE: Audiobahn strongly recommends that you operate your system at low volumes prior to the completed installation of your Audiobahn speakers. This will allow a test of the speaker before securing it to its permanent location. Caution: Make sure that all speaker wiring is fully protected from cuts, tears and possible wear. All short circuits developing as a result could severely damage the source unit or possibly the amplifier as well as the speakers themselves.
Installation Wiring Audiobahn recommends using at least 18-gauge wire with your new speaker system. Thinner gauge wire may easily be severed and can cause damage to your system should any bare wires come in contact with the vehicles chassis. Make sure that your audio system is off while installing and connecting your new Audiobahn speaker. Failure to do so could result in damaging the speaker beyond repair. This is not something that would be covered under the manufacturer warranty.
Installation Securing the Speaker Once you have tested your system and confirmed that it is operating properly, turn off your system and prepare for the mounting of the speaker. 1. Position the speaker into the mounting hole and confirm the correct mounting location and hole placement. Screw clips are provided to insure a snug fit. Place crew clips over the metal surface and line up the hole with the hole you have previously drilled. Place the speaker into the hole.
Troubleshooting In the event that your Audiobahn speakers appear to require service we ask that you first do a little troubleshooting to determine if the problem is actually the speaker, or a problem located in a different part of the vehicle such as the amplifier, wiring, fusing or possibly the source unit.