System 10 Portable Camera-Mount Wireless Digital Wireless System Installation and Operation SYSTEM ID RX RF TX PEAK PAIR PAIR CHARGE MONITOR ATW-1701 UniPak® Transmitter System ATW-1702 Handheld Microphone System
System 10 Portable Camera-Mount Wireless Installation and Operation CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE.REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE. CERTIFICATION: THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
System 10 Portable Camera-Mount Wireless Installation and Operation Receiver Installation Location For best operation the receiver should be at least 3' (1 m) above the ground and at least 3' (1 m) away from a wall or metal surface to minimize reflections. Keep the receiver antennas away from noise sources such as other digital wireless equipment, microwave ovens, as well as away from large metal objects. Keep System 10 receiver 30' (9 m) away from wireless access points.
System 10 Portable Camera-Mount Wireless Installation and Operation ATW-T1002 Transmitter Setup Controls and Functions Battery Selection and Installation Two alkaline AA batteries are recommended. When inserting the battery, observe correct polarity as marked inside the battery compartment. Power / Battery / Mute Status Indicator Level Control System ID Display Pairing Switch Battery Compartment Screwdriver Figure F — ATW-T1002 Handheld Transmitter Handheld Transmitter Battery Installation 1.
System 10 Portable Camera-Mount Wireless Installation and Operation Microphone / Instrument Level Control LR6,AA Pairing Switch Screwdriver System ID Display Battery Compartment Figure G — ATW-T1001 UniPak Transmitter ® UniPak® Transmitter Battery Installation 1. Slide off the battery cover. 2. Carefully insert two fresh AA alkaline batteries, observing polarity markings. 3. Replace the battery cover (Fig. G).
System 10 Portable Camera-Mount Wireless Installation and Operation System Operation Turn down the headphone volume control and the camera/mixer level before starting up the wireless system. Do not switch on the transmitter yet. Receiver on... Press and hold receiver power button to turn receiver on. Power/Battery indicator will glow green and the blue System ID number on the front panel will illuminate. If the Power/Battery indicator flashes green, the receiver’s battery needs to be charged.
System 10 Portable Camera-Mount Wireless Installation and Operation 6. Repeat for each additional transmitter. Remember to switch off all transmitters already paired before adding a new one and to use a unique ID number for each transmitter. Note: With all transmitters turned off, the receiver’s System ID Display will cycle through all currently paired ID numbers. Turn on a transmitter to activate its pairing with the receiver. The receiver recognizes only one transmitter at a time.
System 10 Portable Camera-Mount Wireless Installation and Operation Specifications Overall System Operating Frequencies Dynamic Range Total Harmonic Distortion Operating Range Operating Temperature Range Frequency Response Audio Sampling 2.4 GHz ISM band >109 dB (A-weighted), typical <0.