User manual Mixer Amplifier MT-AMP 06 Tuner module CD/MP3 module … to make people listen ic audio Mixer Amplifier MT-AMP 06 CDT Status 11/2006
MT-AMP 06 CDT ic audio Mixer Amplifier - Front - Mixer Amplifier - Rear - 20060651 EN 2
Content Preperation Unpacking 5 ic audio Device Functions - Rear Side - Safety Instructions 5 General Information 5 115V and 230V Mains Connection 15 Cooling 6 24V Battery Connection 15 Desktop Mounting 6 100V/8W Speaker Output 16 Aerial Connection 17 LINE OUT 18 Special Characteristics Paging Microphone 7 Output Function 7 Common Function 7 Inputs 7 Outputs 7 LINE IN AUX19 Priorities 20 Input sensitivity MIC 1 20 Telephone Input 21 Chime 21 MONITOR OUTPUT 22 Paging Mic INPUT (12-pin) 22 Top view of a
Preperation ic audio Unpacking Please note the unpacking instructions - Unpacking - Safety Instructions - General Information Safety Instructions Please note the safety instructions before connecting the MT-AMP 06 - Cooling - Desktop Mounting General Information Instructions for the installation Cooling Please note the ventilation - cooling guidelines Desktop Mounting Please note the positioning of the Mixer Amplifier EN 4
Preperation ic audio General Information Unpacking Please verify if the following parts were delivered: ! line cord Safety instructions ! DO NOT run microphone cables near mains, data, telephone or 100V line cables. ! DO NOT run 100V line cables near data, telephone or other low voltage cables. ! DO NOT exceed 90% of the amplifiers output power when using 100V line (speech only). ! DO NOT exceed 70% of the amplifiers output power when using 100V line (high level background music).
Preperation ic audio Cooling The mixer amplifer pulls fresh air through the small holes in the bottom sheet and pushes the exhaust air through the long holes in the top sheet. Please make sure that the internal space of the rack system is cooling and you have a room maximum temperature of 40°C.. We recommend to install a cooling system at the rear site of the racksystem to support the transport the exhaust air in the racksystem.
Special Characteristics ic audio Paging Microphone Functions ! 4 Microphone inputs with different Priorities ! 1 AUX - Paging Microphone Functions Output Function - Output Function - Common Function ! 6 Zones switchable and adjustable ! Music muting ! Pre-Amplifier Output - Inputs Common Function - Outputs ! ! ! ! 115V and 230V Mains Connection 24V Battery Connection Monitor Output CD/MP3 - Tuner Mode Inputs ! ! ! ! AUX 4 Microphones Paging Microphone Input (12-pin) Telephone/Emergency Connection
Device Functions - Front side - ic audio LED - Display Display for the activation ON/OFF - Switch - LED - Display Setting - up the Mixer-Amplifier - On/Off - switch Zoning - Zoning Choosing the Output Zone - VU-Display VU-Display - Microphone Input MIC 1 Shows the saturation degree of the Mixer Amplifier - Microphone Controller Microphone Input MIC 1 - LINE - Controller LINE - Select: switch AUX/Tuner/CD-MP3/OFF Connecting a microphone Microphone Controller - Controller Bass and Treble Contr
Device Functions - Front side - ic audio LED - Display LED - Display The LED-Display shows the operational readiness of the Mixer Amplifier. ON/OFF - Switch Zoning With this switch you turn on the apparat. Position I = apparat is on Position 0 = apparat is off After turning the machine on, the LED is shining blue. Before turning the machine on, the Master controller should be set to a low volume.
Device Functions - Frontside - ic audio VU - Display The VU-Display shows the saturation degree of the Mixer Amplifier. The green LED’s indicates the level which can be run continously without any interferences. The red LED is iluminated at the full saturation degree only. This level is not appropriate for enduring operation. VU meter - Display: -25db, -18db, 10, 6, 0db. Microphone Input The first microphone MIC1 is prior to all others. MIC1 being in use automatically gates all other microphones.
Device Functions - Frontside - ic audio Microphone Controller Using this controller you can set the volume of the microphones. Microphone Controller LINE - Select: switch AUX, Tuner, CD-MP3, OFF LINE - Controller You can activate connected signal soureces with the LINE - Select switch. The volume of the connected Signal Sources can be adjusted by the LINE - Controller switch. This could be a built-in CD-Player, a optional Tape Deck or a built-in Tuner.
Device Functions - Frontside - ic audio Bass and Treble Controller Controller Bass and Treble By using this controller you can adjust the reproduction of deep and high frequencies. The bass control lifts or lowers frequencies near to 100Hz at 10dB. The treble-control has the same effect on frequencies near to 10.000Hz. Master Controller The master control drives the volume of all signals being processed by the amplifier. Signals of the TEL/EMERgency input are excepted.
Device Functions - Frontside - ic audio CD/MP3-Player and Tuner are optional items 6 7 8 9 CD Operation 1. Select CD mode with LINE select switch. 2. Press Power key on CD-Player 3. Load disc into player and Play starts automatically 4. Press Pause key and the play will be suspended. Press Pause key to resume play. 5. Press the Next keys (6+7) to select tracks 6. Press the Random key, random appears in the display and tracks will be played out of the sequence. 7.
Device Functions - Rearside - ic audio 115V and 230V Mains Connection Selector to adapt the mains connection 24V Battery Supply Connection to UPS - 115V and 230V Mains Connection - 24V Battery Connection - 100V/8W Speaker Output - Aerial Connection - LINE OUT 100V/8ohm Speaker Output Terminal for 100V/8ohm - speakers Aerial Connection Connection of FM an AM Antennas LINE OUT Connecting an additonal amplifier - LINE IN AUX LINE IN AUX - Priorities - Input sensitivity MIC 1 - Telephone Input - Chime
Device Functions - Rearside - ic audio 115V and 230V Mains Connection Mains Selector The amplifier is factory set at 230 V(AC) mains voltage. The Mains Selector is at the rearside of the Mixer Amplifier. You can set the switch to 115V if neccessary by pushing the slide switch from right to left. Please disconnect the mains cable before changing the voltage supply. Ensure yourself that the device is set to the local mains voltage before you connect it.
Device Functions - Rearside - 100V Speaker Output The amplifier provides six different 100V speaker Zones. Additionally you can connect the speakers with one 25V or 70V Zone. ! The 100V - Output reproduces all signals processed by the Mixer Amplifer operated in the standard mode. ic audio 8ohm Speaker Output This output allows connection of standard low impedance speakers. The minimum load impedance must be 8ohm.
Device Functions - Rearside - ic audio Aerial Connection The MT-AMP 06 provides the possibility to connect two antennas (FM and AM) at the rearside of the gear. The connection can be done by the AMclamps oder the FM jacket.
Device Functions - Rearside - ic audio LINE OUT These standard RCA phono sockets provide a mixed output suitable for connection of an amplifier. Please note: The connection of an power amplifier is providing you an additional zone. This zone is not adjustable (Music/Speech, Speech only). The power for the 6 zones will remain at 240W.
Device Functions - Rearside - ic audio LINE IN (CD/AUX) The equipment provides an auxiliary input which may be used for connecting of other signal sources such as a CD- or Cassette player. A slide switch is located on the front panel for selection of Aux and CD. The line level control operates on each of the input sources. To operate select the desired music source using the slide switch and turn the "Line" control clockwise to increase the volume or anticlockwise to reduce the volume.
Device Functions - Rearside - ic audio Microphone input with XLR-Jack XLR-Input Mic 1 input is either a balanced standard 1/4” stereo jack on front panel or XLR on the rear panel (with selectable phantom power). Mic1 input has VOX priority which will be override Mic2-4 and AUX (LINE) input signals but not the Telephone input. Mic2-4 inputs are XLR with selectable phantom power located on the rear panel.
Device Functions - Rearside - ic audio Telephone Input This input is for emergency announcements / signals and is not effected by the Master Control. The input level can be set by rotary control on the rear panel. The TEL input has the highest priority and will override all other inputs. The volume can be adjusted by the controller on the rear side. The TEL input has the highest priority and will override all other inputs.
Device Functions - Rearside - ic audio MONITOR OUTPUT If the speaker zone is not in the same room as the amplifier you can supervise the output with the connectors on the terminal strip marked as MONITOR OUTPUT. There are several options. 1. Connection of an ear phone at the terminal output 600W and 1V. 2. Connection of a speakers at the terminal output 8W and 1W.
Device Functions - Rearside - ic audio Top view of all functions 100V Line Paging MIC Microphone FM Antenna AM Antenna 20060651 MONITOR ZONE 6 ZONE 5 ~ ZONE 4 GND ~ ~~ GND Amplifier Telephonesystem ZONE 3 ZONE 2 ZONE 1 TUNER CD EN 23
Further Information ic audio Technical Specifications Containing all technical specifications Block Plugging Diagram - Technical Specifications - Block Plugging Diagramm - Index EN 24 Circuit construction Index Content in alphabetical order
Further Information ic audio Technical Specifications Type Mixer Amplifier Modell MT-AMP 06 AC 115V / 230V , 50 / 60Hz ± 10% selctable DC 24V (Max 10% deviation) 360W 240W SPEAKER OUTPUTS: MUSIC/SPEECH: 8ohm, 25V, 70V, 100V selectable LINE OUT: 600ohm, 1V Mains Voltage Supply Battery Voltage Output power max: Rated power: Outputs Inputs MOH OUTPUT: 8ohm 1 watt / 600ohm,1V balanced. MIC 1: 250ohm, 1mV, symmetric with phantom power selectable, to LINE switchable.
Further Information Block Plugging Diagram EN 26 ic audio
Further Information ic audio INDEX A 115 V and 230 V Power supply M Master Controller 12 Microphone Inputs 10 Microphone Controller 11 MONITOR OUTPUT 22 B Bass and Treble Controller 12 Battery Connection 15 Block Plugging Diagram 26 OON/OFF - switch 9 C CD-Player 13 Outputs 7 Chime 21 PPriorities 20 D Desktop-Mounting 6 I K S Safety instructions 5 Speaker Output 16 Inputs 7 Input sensitivity MIC 1 20 T Telephone Input 21 Technical Specifications 25 Top view of all functions 23 Tuner 13 Cooli
ic audio GmbH Boehringerstraße 14a 68307 Mannheim / Germany Fon:+49(0)621/ 77096-0 Fax:+49(0)621/ 77096-26 www.ic-audio.com Email: info@ic-audio.