User's Manual

TM
B-007
Product Structure
TM
1
2
3
4
5
M3
6
TM
How to setup
TM
1
2
3
4
5
6
7
8
9
0
*
#
TM
M3
TM
1
2
3
4
5
6
7
8
9
0
*
#
TM
M3
B007V080813
Designed/Manufactured by
Telecom Industrial Co., LTD.
Http://www.bananaz.cn E-mail: [e-mail]
TM
1. Liquid Crystal Display
2. Multi-Function button
3. Up button
4. Down button
5. Receiver
6. Battery case
Universal phone holder
Features
1. Range of FM transmission:
88.1MHz ~ 107.9MHz (100kHz/step)
2. LCD displays frequency transmission
3. Four frequency transmission saved
points
4. Three buttons: multi-function, up, and
down
5. Automatic shut-off feature after
30-45 minutes of silence
How to Operate
1. To turn the unit on press the Multi-Function button. The LCD will
show the last used frequency.
2. When you receive a call, simply answer your phone and push your preset
radio button to either of the saved frequencies shown on the LCD.
3. To make a call, turn your B-007 on and push your preset radio button
to either of the frequencies shown on the LCD. Then simply place the call.
4. When you are finished using your phone, it is strongly recommended that
you turn your B-007 off. This will greatly increase the life of the battery.
5. To turn your B-007 off press and hold the Multi-Function button for 4 seconds.
The B-007 will automatically turn itself off after 30-45 minutes of silence.
6. To adjust the frequency manually use the up and down buttons to
scan the channels by 0.1MHz per each press of the button. For
TM
TM
* Fits for any
type of mobile
phone
Universal FM Handsfree
Trouble Shooting
1. If you or the person you are calling can hear an echo, simply decrease
the volume of your radio
2. If you are experiencing a weak transmission signal or poor reception.
In the first instance check the radio frequency displayed on the B-007
matches the frequency shown on your radio.
3. If the B-007 LCD does not come on when you press the Multi-Function
button is pressed, check the battery does not need re-placing.
Conformity Declaration
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, Pursuant to Part 15 of the FCC Rules. These
limits are designed to Provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off an on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
automatic adjustment press and hold down the up and down buttons.
7. After adjusting the frequency, the unit will automatically save the
current channel. This will be shown by a M1, M2, M3 or M4 symbol
in the top left hand corner of the LCD screen. Each M number will
store an individual channel.
8. To switch between the stored numbers press the Multi-Function button
+
-
Battery
replacement
TM
M3
Notice:
We include the
EVA pad for well
protecting the soft
rubber of the
microphone.
Please remove the
EVA pad before
using the B-007. If
not using the B-007,
please attach the
EVA pad inside the
clip for protecting
the soft rubber of
the microphone.