Wall Speaker WX502 AUDAC PROFESSIONAL AUDIO EQUIPMENT Wall Speaker WX502 User Manual & Installation Guide
Warning Only use the correct amplifier output voltage and impedance. Exceeding these limits could cause fire or other failures. Avoid explosions: do not use the speaker around gasoline, thinner or other combustibles. Only install the speaker in locations that can structurally support the weight of the speaker. Not doing so may result in the speaker falling down. Do not use any other method than specified to mount the speaker.
Installing the WX502 Mounting the loudspeaker The loudspeaker can be mounted both horizontally and vertically by means of the supplied mounting bracket. For mounting the loudspeaker on the desired mounting location, the mounting bracket should be removed from the loudspeaker. This can be done by loosening the screws on either side of the loudspeaker. After this is done, the mounting holes should be indicated. For a stable mounting of the loudspeaker it should always be fastened by two screws.
Additional information WX502 Technical specifications: RMS Power Max Power Nominal Impedance Line transformer power tappings 50 W 100 W 8 Ohm 250 Ohm / 40 W 500 Ohm / 20 W 1000 Ohm / 10 W 87 dB 104 dB 102 dB 90 Hz - 18 kHz 70 Hz - 18 kHz 2500 Hz 110° 110° 1” HF + 51/4” LF 212 x 147 x 136 mm 2,52 kg ABS Wall bracket Black White Silver Sound pressure 1W / 1m Sound pressure max W / 1 m @ 8 Ohm Sound pressure max W / 1 m @ 100V Frequency response -3 dB Frequency response -10 dB Cross-over frequency Horizonta