Data Sheet

44
Appendix G — Flush Mount Hardware
1. INTRODUCTION
This mounting device enables the dome camera to be mounted to the suspended ceiling.
The mounting clamps, which are affixed to the ceiling tile, attach directly to the dome's mounting
base for a quick and easy installation.
2. SPECIFICATIONS
Figure 10 – Dimension Drawing
3. INSTALLATION
NOTE: The ceiling tile cannot be thicker than 0.9inch (2.4cm).
A. Remove the ceiling tile from the ceiling. Draw a circle whose diameter is 184mm on the tile
(You can use the carton with a hole). Cut the circle out of the ceiling tile. [ Figure 11 ]
B. To install the dome camera, fasten the bottom case to the base bracket [ Figure 17, ② ]
using 4 screws on the bottom case by twisting the dome camera. [ Figure 12 ]
C. Insert the flush mount into the ceiling and turn the lever clamp [ Figure 17, ④ ] using
3 screws. [ Figure 17, ⑥ ]
(If ceiling tile is soft use carton with a hole between ceiling tile and clamps)
D. Fix the trim ring [ Figure 17, ① ] to the flush mount. [ Figure 15 ]
NOTE: To increase the safety, screw safety ring
string to the guide bracket and something
which can prevent falling incidentally.
- Construction Steel and injection-molded plastic
- Weight Approx. 2.5 kg (5.5 lbs)
- Dimension Diameter = 219.5mm, Height = 146.5mm